Table of Contents
Advertisement
Available languages
Available languages
Quick Links
WARNING:
To reduce the risk of injury, user must read and understand
the operator's manual for their riding lawn mower before
using this accessory. Save these instructions. Refer to them
frequently and use them to instruct other users. If you loan
someone this product, loan them these instructions also.
PACKING LIST
Bagging Blades (2)
Hitch Pin
Bags (2)
Lower Bagger Tube
INSTALLING THE BAGGING KIT
This kit includes a bagger and special mower blades designed
to be used when bagging. Install the blades first, then install
the bagging kit.
REMOVING THE CUTTING DECK
See Figure 1.
If desired, the cutting deck can be removed from the mower to
make accessing the blades easier when changing.
Make sure drive levers are in open position and blade engage
knob is down.
Stop the motor, remove the start key, and set the parking
brake.
Disconnect both cables that connect the cutting deck to the
mower.
Lower the cutting deck to its lowest position.
Remove the 3 hitch pins and washers that secure the cutting
deck in place.
Slide the deck out from under the mower.
Reverse the process to reattach the cutting deck to the
mower.
INSTALLING BAGGING BLADES
See Figures 2 - 3.
WARNING:
Only use replacement blades and blade bolts authorized
by the manufacturer of your riding mower. Unauthorized
blades and/or blade bolts could break, allowing the blade
to come loose, resulting in possible serious personal injury
and damage to the mower.
NOTE: Make certain all parts are replaced in the exact order in
which they were removed.
Make sure drive levers are in open position and blade engage
knob is down.
Stop the motor, remove the start key, and set the parking
brake.
ACRM015 BAGGING KIT
FOR USE WITH RYOBI ELECTRIC ZERO TURN MOWER
Bagger Bracket
Bagger Cover
Upper Bagger Tube
CABLE (x2)
CUTTING
DECK
WASHER
WRENCH
BLOCK OF WOOD
Raise the height of the cutting deck to its highest position
to allow access to blades.
NOTE: If necessary, raise the mower by placing on a lift or
using a jack and jack stands, or remove the cutting deck
as described in the previous section to gain access to the
blades.
HITCH PIN
Fig. 1
BLADE
Fig. 2
Advertisement
Table of Contents
Related Manuals for Ryobi ACRM015
Summary of Contents for Ryobi ACRM015
- Page 1 ACRM015 BAGGING KIT FOR USE WITH RYOBI ELECTRIC ZERO TURN MOWER WARNING: CABLE (x2) To reduce the risk of injury, user must read and understand the operator’s manual for their riding lawn mower before using this accessory. Save these instructions. Refer to them frequently and use them to instruct other users.
-
Page 2: Fig. 4
BLADE WARNING: CIRCLE POST If raising the mower to access the blades, make sure the SHAFT BLADE HALF mower is properly secured and the parking brake is set CIRCLE POST before proceeding. Failure to properly secure the mower could cause it to fall, resulting in possible death or serious personal injury. -
Page 3: Table Of Contents
ELASTIC BAND FRAME COVER SHAFTS FRAME OPENINGS Fig. 5 SIDE INSERT SIDE INSERTS COVER Fig. 10 SLEEVE MESH POCKET COVER FRAME CHANNELS INSIDE OF COVER HOLE Fig. 6 Fig. 7 UPPER COVER COVER TUBE FRAME Fig. 11 CHANNELS LOWER TUBE Fig. -
Page 4: Fig. 13
USING THE BAGGING KIT See Figures 14-15. UPPER WARNING: TUBE Added accessories can affect the stability of the mower when operating on slopes. Use additional care when mow- ing on slopes with the bagging kit installed. Never attempt to tow with the bagging kit installed. Failure to follow these instructions can result in death or serious personal injury. -
Page 5: Fig. 1
ENSEMBLE D’ENSACHAGE ACRM015 À UTILISER AVEC LA TONDEUSE ÉLECTRIQUE À BRAQUAGE ZÉRO RYOBI AVERTISSEMENT : CÂBLE (x2) Pour réduire les risques de blessure, l’utilisateur doit lire et comprendre le manuel d’utilisation de son tondeuse électrique autoportée avant d’employer cet accessoire. -
Page 6: Fig. 3
chandelles ou retirer le plateau de coupe comme décrit au TIGE POUR chapitre précédent afin d’avoir accès aux lames. LAME TIGE POUR CERCLE ARBRE LAME DEMI- AVERTISSEMENT : CERCLE Lorsque la tondeuse est soulevée afin de pouvoir accéder aux lames, s’assurer que la tondeuse est correctement immobilisée et que le frein à... - Page 7 CORDON ÉLASTIQUE OUVERTURES ARBRES DU CHÂSSIS CHÂSSIS DE COUVERCLE Fig. 5 PANNEAU LATÉRAL PANNEAUS Fig. 10 LATÉRAUX COUVERCLE MANCHON POCHETTE EN CHÂSSIS DE MAILLE COUVERCLE TROU TUBES INTÉRIEUR DU COUVERCLE Fig. 6 Fig. 7 TUBE SUPÉRIEUR CHÂSSIS DE COUVERCLE COUVERCLE Fig.
- Page 8 UTILISATION DE LA ENSEMBLE D’ENSACHAGE Voir les figures 14 et 15. TUBE SUPÉRIEUR AVERTISSEMENT : Les accessoires ajoutés peuvent nuire à la stabilité de la tondeuse pendant la coupe effectuée sur des pentes. LANGUETTE Effectuer les déplacements de tondeuse sur les pentes avec grande prudence lorsque la ensemble d’ensachage est installée.
- Page 9 KIT PARA EMBOLSAR ACRM015 PARA USAR CON LA PODADORA ELÉCTRICA DE GIRO CERO RYOBI ADVERTENCIA: CABLE (x2) Para reducir el riesgo de lesiones, el usuario debe leer y comprender el manual del operador de la podadora de pasto tipo tractor antes de usar este accesorio. Guarde estas instrucciones.
- Page 10 MONTANTE ADVERTENCIA: DE LA MONTANTE DE Si levanta la podadora para acceder las cuchillas, asegúrese CUCHILLA LA CUCHILLA de que la podadora se encuentre asegurada correctamente CIRCULAR SEMICIRCULAR y el freno de estacionamiento esté colocado antes de proceder. Si no asegura la podadora correctamente puede provocar una caída, lo que podría causar la muerte o posibles lesiones físicas graves.
- Page 11 CORDÓN ELÁSTICO ABERTURAS EJES DEL DE LA BASTIDOR BASTIDOR DE LA CUBIERTA Fig. 5 INSERTO DE LATERAL INSERTOS DES LATERALES CUBIERTA Fig. 10 MANGA BOLSILLO DE BASTIDOR DE MALLA LA CUBIERTA CANALES INTERIOR DE LA CUBIERTA ORIFICIO Fig. 6 Fig. 7 BASTIDOR TUBO CUBIERTA...
- Page 12 CÓMO USAR EL KIT PARA EMBOLSAR Vea las figuras 14 y 15. TUBO SUPERIOR ADVERTENCIA: Los accesorios agregados pueden afectar la estabilidad de la podadora si se usa en pendientes. Tenga sumo cuidado LENGÜETA cuando pode en pendientes si el kit para embolsar está instalado.