Sealey SL2D.V3 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Indoor use only
instructions
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are
‰
adhered to when using these lockers. Wear protective gloves.
Locate locker in a suitable work area.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
WARNING! Use locker on level and solid ground, preferably concrete.
‰
Keep the locker clean and tidy in accordance with good workshop practice.
9
Keep children and unauthorised persons away from the work area.
9
DO NOT use the locker for any purpose other than that for which it is designed.
8
DO NOT use the locker outdoors.
8
DO NOT get the locker wet or use in damp or wet locations or areas where there
8
is condensation.
DO NOT clean the locker with any solvents which may damage the surfaces or the
8
protective coating.
2. INTRODUCTION
Double locker system suitable for a wide variety of commercial applications with clothes hanger
bar. Doors are ventilated and fitted with cylinder lock.
3. SPECIFICATION
Model No:................................................................SL2D.V3
Doors: ..........................................................................2 door
Overall Size (W x D x H): ......................380 x 450 x 1850mm
4. ASSEMBLY
4.1. Lay out the back panel and the two side panels (fig.1). The side panels have a cut-out at the front (fig.2). Fit the left hand side panel to
the back panel, secure using the bottom and two middle screws only.
4.2. Fit the right hand side panel to the back panel, using the three lower screws only to secure (fig.3).
4.3. Carefully stand the unit up, ensuring that the panels are not twisted.
4.4. Fit the door frame panel into the unit from the inside locating the frame with the side panels at the top and bottom.
4.5. Fit the locker top from the inside with the two holes at the back lined up with the two holes in the back panel.
4.6. Bend the tabs in at the front of the top, making sure that they locate into the locking holes
in the door frame (figs.4 & 5).
© Jack Sealey Limited
2 DOOR LOCKER
MODEL NO:
Wear protective
gloves
fig.1
Original Language Version
SL2D.V3
SL2D.V3
fig.2
SL2D.V3 Issue 2 (4) 19/06/23