HOLOPHANE Utility Arlington LED Installation And Maintenance Manual

LED Important Safety Instructions
SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER AFTER INSTALLATION

To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards please read
all warnings and instructions included with and on the fixture box and all fixture labels.

Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.

Installation and service of luminaires should be performed by a qualified licensed electrician.

Maintenance of the luminaires should be performed by person(s) familiar with the luminaires' construction and operation and any hazards involved.
Regular fixture maintenance programs are recommended.

It will occasionally be necessary to clean the outside of the refractor/lens. Frequency of cleaning will depend on ambient dirt level and minimum light
output which is acceptable to user. Refractor/lens should be washed in a solution of warm water and any mild, non-abrasive household detergent,
rinsed with clean water and wiped dry. Should optical assembly become dirty on the inside, wipe refractor/lens and clean in above manner, replacing
damaged gaskets as necessary.

DO NOT INSTALL DAMAGED P RO DUCT! This luminaire has been properly packed so that no parts should have been damaged during transit.
Inspect to confirm. Any part damaged or broken during or after assembly should be replaced.

Recycle: For information on how to recycle LED electronic products, please visit www.epa.gov.

These instructions do not purport to cover all details or variations in equipment nor to provide every possible contingency to meet in connection with
installation, operation, or maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently
for the purchaser's or owner's purposes, this matter should be referred to Acuity Brands Lighting, Inc.
WARNING: RISK OF ELECTRIC SHOCK
✓
Disconnect or turn off power before installation or servicing.
✓
Verify that supply voltage is correct by comparing it with the
luminaire label information.
✓
Make all electrical and grounded connections in accordance with
the National Electrical Code (NEC) and any applicable local code
.
requirements
✓
All wiring connections should be capped with UL approved
recognized wire connectors.
CAUTION: RISK OF INJURY
✓
Wear gloves and safety glasses at all times when removing
luminaire from carton, installing, servicing or performing
maintenance.
✓
Avoid direct eye exposure to the light source while it is on.
Always read the fixtures complete installation instructions prior to installation for any additional fixture specific warnings.
Please see product specific installation instructions for additional warnings or any applicable FCC or other regulatory statements.
For a complete listing of product Terms and Conditions, please visit www.acuitybrands.com.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS!
Failure to follow any of these instructions could void product warranties.
WARNING: RISK OF BURN
✓
Allow lamp/fixture to cool before handling. Do not touch enclosure
or light source.
✓
Do not exceed maximum wattage marked on luminaire label.
✓
Follow all manufacturer's warnings, recommendations and
restrictions for: driver type, burning position, mounting
locations/methods, replacement and recycling.
CAUTION: RISK OF FIRE
✓
Keep combustible and other materials that can burn, away from
lamp/lens.
✓
Do not operate in close proximity to persons, combustible
✓
materials or substances affected by heat or drying.