Table of Contents
Advertisement
® Best Stations Memory Button
Automatically tunes strong frequencies and assigns them to preset
buttons
1 through 6 for one-touch
automatic
tuning. The
best
stations memory function is activated by pressing this button for ap-
proximately 2 seconds. The best stations memory function is indi-
cated by ——— flashing on the display, and this function can be can-
celed by pressing the band switch. The frequency display returns
once the best stations memory function is complete. The frequency
displayed at this time is of the strongest station assigned to preset
button 1 by the best stations memory function.
®@ 6 best (strongest) frequencies are memorized in the 6 preset but-
tons in the order of their strength, the strongest one being as-
signed to preset button 1.
@ The frequencies previously assigned to the preset buttons are re-
tained when 6 frequencies cannot be located.
@ The best stations memory is in operation while -——
is flashing
on the display.
®@ Stereo/Monaural Switch
This switch is used to change from stereo to monaural for FM broad-
casts, and is usually {eft in the stereo position. When a stereo broad-
cast is received, the stereo indicator will illuminate. With the "Super
Tuner Il" function, stereo broadcasts can always be enjoyed in their
optimal reception mode. If excessive noise is present, pressing this
switch allows monaural reception of the broadcast.
® Local Station Switch
Pressing this switch increases the seek threshold level so that only
relatively strong stations can be tuned in {focal indicator will ilumin-
ate on the display).
Local seek threshold
level can be selected
among four jevels for FM and two levels for AM,
Holding this switch down
for approximately 2 seconds and then
pressing the right side of the tuning button changes the dispiay
form L-1, L-2, L-3 to L-4. Pressing the left side of the tuning button
changes the display from L-4, L-3, L-2 to L-1 (L-1 and L-2 for AM).
The bigger the number, the higher the seek threshold becomes and
only relatively strong stations can be tuned in.
® Fader Control
This contral is used to adjust the balance between the front and rear
speakers when using 4 4-speaker system. Turning the control to the
right decreases the volume of the rear speakers, while turring it to
the left decreases the volume of the front speakers. With 2-speaker
systems, set this control to the upright position.
® Loudness Switch
When playing back 4 tape or listening to the radia at low volume,
the low and high tones are srnphasized and more clearly heard by
pressing this switch.
Seek Tuning
Press both ends of tuning button, and tuning to the next higher or
lower broadcast on the band can be accornplished automatically by
simply pressing either the right or left side of the tuning button. FM
frequencies change in 0.2 MHz steps while those in the AM band
change in 10 kHz steps.
Advertisement
Table of Contents
