Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Aim Manuals
  4. Keypad
  5. K8 Open
  6. User manual

Aim K8 User Manual

Hide thumbs Also See for K8:
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
User Guide
K8 Keypad
Release 1.00

Advertisement

loading
Need help?

Need help?

Do you have a question about the K8 and is the answer not in the manual?

Questions and answers

Related Manuals for Aim K8

Summary of Contents for Aim K8

  • Page 1 User Guide K8 Keypad Release 1.00...
  • Page 2 Keypad K8 is intended to be used exclusively in an AiM network. Actually you may only connect it to AiM PDM08 or PDM32. It features 8 pushbuttons whose status is constantly transmitted to the Network Master through AiM CAN connection. The buttons are fully configurable using AiM RaceStudio3 Software.
  • Page 3 Here below the CAN cable with its pinout is shown. The cable part numbers are: • V02554790 500mm length • V02554810 1000mm length • 2000mm length V02554820 • 4000mm length V02554830...

  • Page 4: Software Configuration

    3 – Software configuration For configuring K8 Keypad please download AiM RaceStudio 3 software from AiM website at aim-sportline.com Software/Firmware download area. AiM - Software/Firmware download (aim-sportline.com) After having installed the software, please run it and follow these steps: •...
  • Page 5 • pushbuttons status is transmitted to K8 through AiM CAN bus • the status of each pushbutton at power OFF can be restored at the following power ON •...
  • Page 6 Toggle Setting the pushbutton as Toggle: the status is: ON when the button is pushed once and it remains ON till when is pushed again OFF when the button is pushed the second time. Please note: both status ON and OFF can be freely associated to a numeric value. Multi-status Setting the pushbutton as Multistatus the status may assume different values.
  • Page 7 You can even define a time threshold.. In this case the pushbutton is set at two different values you may define according to how long you push it. To do so enable “use timing” checkbox on the top of the setting panel. In this case the pushbutton is set at two different values you may define according to how long you push it.
  • Page 8 4 – Keypad K8 Open K8 keypad is also offered in an “Open” version that allows you to define the CAN streams. This version is intended to be used when an AiM master device is not present but, of course, you can anyway use it in an AiM installation. In order to do so, you have to follow these steps: •...