Advertisement
Advertisement
Table of Contents
Related Manuals for Aim K8
Summary of Contents for Aim K8
- Page 1 User Guide K8 Keypad Release 1.01...
- Page 2 1 – Introduction The K8 Keypad is exclusively used on an AiM network, connecting only to the AiM PDM08 or PDM32. It features 8 pushbuttons whose status is constantly transmitted to the Network Master through an AiM CAN connection. The buttons are fully configurable using AiM RaceStudio3 Software.
- Page 3 1000mm – V02554810 2000mm – V02554820 4000mm – V02554830 3 – Software configuration For configuring the K8 Keypad, please download AiM RaceStudio3 software from the AiM website at aim- sportline.com Software/firmware download area: AiM - Software/Firmware download (aim-sportline.com) After having installed the software, run it and follow these steps: Enter the Configuration Menu by clicking the icon highlighted below: •...
- Page 4 The pushbutton status can be set as Momentary, Toggle or Multi-status as explained in paragraph 3.1.1. • It is possible to set a time threshold to manage short and long button compression in different ways. Pushbutton status is constantly transmitted through AiM CAN bus. • •...
- Page 5 The status is: o ON when the pushbutton is pushed o OFF when the pushbutton is released Please note: both status ON and OFF can be freely associated with a numeric value When setting the pushbutton as Momentary, you can associate a command to each pushbutton by pressing the related button highlighted below.
- Page 6 Multi-status When setting the pushbutton as Multi-status, the status may assume different values that change every time the pushbutton is pushed. This setting is useful, for example, to select different maps or to set different suspension levels etc. You can also set a time threshold: in this case, the pushbutton is set at two different values that you may define depending on how long you push it.
- Page 7 To do so enable the “use timing” checkbox on the top box of the setting panels. 3.1.2 – Pushbutton colour configuration Each pushbutton can be set with different colours to indicate the action performed by the driver and the feedback of that action: the pushbutton may be turned –...
- Page 8 The K8 Keypad is also offered in an “Open” version that allows you to define the CAN streams. This version is intended to be used when an AiM master device is not present, but of course, you can use it in any AiM installation. In order to do so, you have to follow these steps: 1- Set the Keypad as “connected to AiM device”.
Need help?
Do you have a question about the K8 and is the answer not in the manual?
Questions and answers