Cuttings Function On Key; Humidifier Key; Internal Light Key - Smeg SDP20 Manual

Remote control
WARNING: WHEN IN STANDBY, THE HOME GARDEN NO LONGER AUTOMATICALLY CONTROLS
ITS INTERNAL CLIMATE.
IN CASE OF A POWER BLACKOUT, THE ELECTRONIC CIRCUIT BOARD WILL RETAIN THE LAST
PROGRAM SET BY THE USER IN THE MEMORY, AND WILL REPEAT IT AUTOMATICALLY WHEN
THE POWER SUPPLY IS RESTORED..

9.3 Cuttings function on key

This key activates the "Cuttings" function, which automatically operates the Home Garden's heating
elements.
This is intended for growing cuttings or immediately after planting seeds. The pots intended for this
function are those around the edge of the lowest level.
When this function is activated, the symbol stays on.
This function can be switched off automatically when the internal temperature exceeds the maximum
permitted value, or manually by pressing the key again at any time.
In certain conditions, the function may not even activate. If for example the external temperature is
greater than that set for the cuttings function, it will not activate and the symbol on the Home
Garden's control panel will flash three times.
WARNING: BY ACTIVATING THIS FUNCTION, THE STEEL SURFACES ON THE TANK SIDES HEAT
UP. IN THAT POSITION THE HEATING ELEMENTS ACTIVATED BY THIS FUNCTION ARE ON. DO
NOT TOUCH THESE PANELS WITH YOUR BARE HANDS BEFORE ALLOWING THEM SUFFICIENT
TIME TO COOL DOWN.

9.4 Humidifier key

This key manually delivers a few jets of water vapour into the Home Garden. Once the series of jets is
finished, or by pressing the key again before the end of the sequence, the appliance will return to normal
operation.
WARNING: THE APPLIANCE'S INTERNAL CIRCUITRY CONTROLS THE AMOUNT OF VAPOUR
DELIVERED INTO IT. ONCE THE MAXIMUM NUMBER OF JETS HAS BEEN REACHED, THE
SYSTEM WILL NOT DELIVER ANY MORE UNTIL A CERTAIN PERIOD OF TIME HAS PASSED.
THE FIRST 20-30 JETS OF VAPOUR DELIVERED BY THE HUMIDIFIER WILL BE LESS INTENSE
THAN SUCCESSIVE ONES.

9.5 Internal light key

This key switches the internal light lamps on and off.
If the lamps are on (at any strength) and you press the key on the remote control, they will turn on at
maximum power for about one minute and then return to their automatically determined strength.
If the lamps are completely off, pressing this key turns them on at full strength and they will stay on for
about one hour.
In both cases, the lamps can be returned to their automatic setting by pressing the key again.
WARNING: DEPENDING ON THE EXTERNAL LIGHTING INTENSITY, THE INTERNAL LAMPS WILL
EMIT A STRONGER OR WEAKER LIGHT. LOW LIGHT OUTPUT DOES NOT INDICATE A
MALFUNCTION; THEY STAY ON DURING THE DAY OR IN STRONG EXTERNAL LIGHTING AT A
LOW SETTING.
39