Page 1
IPTESTBOX Portable vacuum and pressure tester with air compressor for Prolights IP fixtures USER MANUAL English version REV.01-01/24...
Page 2
PROLIGHTS product are trademarks OWNED or licensed by Music & Lights S.r.l., its affiliates, and subsidiaries. PROLIGHTS is a registered trademark by Music & Lights S.r.l. All right reserved. Music & Lights – Via A. Olivetti, snc - 04026 - Minturno (LT) ITALY.
Page 3
6 - CONTROL PANEL DISPLAY AND BUTTONS LAYOUT ................. 07 7 - MENU STRUCTURE 8 - USE 9 - FIRMWARE UPDATE 10 - MAINTENANCE MAINTENANCE THE PRODUCT ..................12 VISUAL CHECK OF PRODUCT HOUSING ..............12 TROUBLESHOOTING ..................... 12 PROLIGHTS - IPTESTBOX...
• Do not reapply power until repairs have been completed. • Refer any service operation not described in this manual to PROLIGHTS Service team or an authorized PROLIGHTS service center.
Page 5
AC mains power and allow to cool for at least 10 minutes before handling. • Only technicians who are authorized by PROLIGHTS or Authorised service partners are permitted to open the fixture. • Users may carry out external cleaning, following the warnings and instructions pro- vided, but any service operation not described in this manual must be referred to a qualified service technician.
3. Micro SD port; 4. USB port; 5. ON-OFF switch; 6. POWER IN: for connection to the Mains 100-240V~/50-60Hz; 7. MAIN FUSE HOLDER: replace a burnt-out fuse by one of the same type only (T2A 250V). Fig 02 PROLIGHTS - IPTESTBOX...
• Connect the power connector into the Mains input socket (100-240 VAC-50/60 Hz). • The product is then ready for its operations and can be controlled through the available input sig- nals on board. • To disconnect power from the product, disconnect the Mains from the socket. PROLIGHTS - IPTESTBOX...
• DOWN: To scroll through the functions of the main menu or decrease the value of the function. • LEFT: To move left in the function. • RIGHT: To move right in the function. • ENTER: To enter the next menu or confirm the displayed value or to activate the function displayed. PROLIGHTS - IPTESTBOX...
ERROR MESSAGE To see any error messages. DEVICE INFO DEVICE LABEL FIRMWARE VERSION View informations about software version. DEFAULT BASIC RELOAD PASSWORD 050 Basic reload wipes all user settings (SD card isn't wiped) ALL RELOAD (Service use) PROLIGHTS - IPTESTBOX...
Page 11
8 - USE IPTESTBOX is a portable tool coming into an ABS case that is capable to test IP rating for multiple PROLIGHTS products. The tool features both vacuum (aspire the air) and pressure (blow the air) test of the lighting fixtures through the internal air compressor, monitoring the pressure behaviour inside the unit housing according to the IP class of the product.
Page 12
Fig. 06 Insert the Adapter into the GORE Valve hole. NOTE: Check the right adapter for your PROLIGHTS IP Product Fig. 07 Connect the air hose to the adapter. Start IP test choosing IP grade of the Product. PROLIGHTS - IPTESTBOX...
3. Insert the MicroSD in the appropriate slot (fig.02, page 05) 4. Turn on the power switch holding ENTER+UP buttons to start IPTESTBOX in BootLoader page. 5. Press ENTER on the file that appears and wait for the operation to complete.
WARNING: the use of alcohol or any other detergent could damage the lenses. • All other service operations on the product must be carried out by PROLIGHTS, its approved service agents or trained and qualified personnel.
Need help?
Do you have a question about the IPTESTBOX and is the answer not in the manual?
Questions and answers