Changing Channels - Sharp AQUOS LC-15L1U Operation Manual

BASIC OPERATION (Continued)
Changing channels by using Channel Select on the remote control
• This LCD TV set allows you to select up to 125 channels (1 to 125). To
select a channel, enter a 2- or 3-digit number.
115
5
0-
Press the
@
button.
Press the
(Q)
button.
Press the ® button.
I
Note: :>
• When selecting a 1-digitchannel number,
do not fail to press the
(Q)
button first.
To select a 1- or 2-digit channel
number (e.g., Channel 5):
Complete the following procedure within 4
seconds.
To select a 3-digit channel number
(e.g., Channel 115):
Complete the following procedure within 4
seconds.
Channel
Select
Press the CD button.
Press the ® button.
I
Note::>
The 3-digit channel number can be
selected only when the receiving mode is
set to "CABLE" in ·"CH-SETTING". (For
details on setting the receiving mode, see
page 43.)
Press FLASHBACK to show the previous
channel.
Tuning operation may take a few seconds to
complete when using the remote control,
because of the wireless transmission speed.
This does not indicate a malfunction.
Changing channels with CH (A)/(V) on the remote control
Air Press CH (A) and the channels change in the order shown below:
2 --) 3 --) . . . --) 68 --) 69 --) 2 --) 3 --) . . .
Press CH (v) and the channels change in the order shown below:
3 --) 2 --) 69 --) 68 --) ... --) 3 --) 2 --) ...
Cable Press CH (A) and the channels change in the order shown below:
1 --) 2 --) 3 --) . . . --) 125 --) 1 --) 2 --) 3 --) . . .
Press CH (v) and the channels change in the order shown below:
3 --) 2 --) 1 --) 125 --) . . . --) 3 --) 2 --) 1 --) . . .