Global Solutions GS1735 Series Operating Instructions

Popcorn Popper
Introduction :
1. Please read instructions before using this appliance.
2. When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock and
injury.
3. Clean machine thoroughly before and after each use following
the cleaning instructions provided below.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions
should always be followed, including the following:
1. Warning! All power must be disconnected at power source before
any service procedure is performed.
2. This appliance must be placed on a level surface.
3. Do not leave this appliance unattended while it is in use.
4. Never immerse the appliance in water.
5. Do not operate the kettle while it is empty.
6. Do not attempt to repair or replace the power cord if it is
damaged. Contact a qualified service agent.
7. Be careful not to touch any hot surfaces. Make sure the power
cord does not come into contact with any hot surfaces.
Electrical Requirements :
Refer to the product tag (serial plate) on the back of the unit for
voltage and wattage requirements. Be sure to plug unit into
grounded outlet with sufficient power.
WARNING: DURING NORMAL OPERATION, THE EXTERIOR
OF THE UNIT IS HOT!
Preparation
1. Remove all packing pieces and lift unit out of the box.
2. Remove any outside packaging.
3. Set unit on a flat, stable, solid surface and position it
away from any water source.
Physical Address: Corporate HQ
301 Meuse Argonne | Hicksville, OH 43526
800.782.6761 • 419.542.7751 • f: 419.542.6690
OPERATING INSTRUCTIONS
April 2, 2024
globalsolutionsfoodequipment.com
4. Position the unit near a power outlet. Avoid the
use of extension cords. Do not run cord under
carpeting or cover with runners or the like. Plug
the unit into a grounded outlet with correct voltage and
sufficient power capacity.
Operation :
1. Plug cord into grounded electrical outlet of the correct
voltage.
Turn on the "HEAT" and "TURN" switches. This will
2.
turn on the kettle heat and stirrer motor. Allow the
kettle to pre-heat for 5 to 6 minutes.
3. Measure out the appropriate amount of popping corn,
seasoning, and oil.
4. Dump the oil in the kettle first. Allow the oil to heat for
approximately 1 to 2 minutes before adding the
popping corn and seasoning.
5. Once the corn has stopped popping, dump the kettle,
ensuring all the corn is emptied from the kettle.
When corn is not being popped the "HEAT" and
6.
"TURN" switches should be turned to the off position.
7. To keep the popped corn warm and add lighting to the
case, ensure that the "WARMING LIGHT" switch is in
the on position.
Cleaning :
NOTE: Proper maintenance plays an important part in the
life span and functioning of the warmer.
1. Always unplug the popper when not in use or when
cleaning.
2. Ensure to disconnect the power supply from the
kettle.
3. Do not immerse the popper in water and avoid getting
water in the top of the case.
4. Clean the popper with a mild detergent and warm
water making sure to remove as much of the salt and
oil as possible. Be sure to clean the inside and
outside surfaces of the kettle. Allow the popper to
completely dry.
5. Dump and clean the kernel catch pan.
Global Solutions Distribution Center/Test Kitchen
4300 E Magnolia Street | Phoenix, AZ 85034
Model Series:
GS1735 & GS1736