Sunheat Thermal Wave TW1500UV Owner's Manual

Infrared zone heating system

Advertisement

Quick Links

INFRARED ZONE HEATING SYSTEM
OWNER'S MANUAL
Model No. TW1500UV
PLEASE SAVE THESE INSTRUCTIONS
WARNING: READ THIS OWNER'S MANUAL CAREFULLY BEFORE USE.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Thermal Wave TW1500UV and is the answer not in the manual?

Questions and answers

Summary of Contents for Sunheat Thermal Wave TW1500UV

  • Page 1 INFRARED ZONE HEATING SYSTEM OWNER’S MANUAL Model No. TW1500UV PLEASE SAVE THESE INSTRUCTIONS WARNING: READ THIS OWNER’S MANUAL CAREFULLY BEFORE USE.
  • Page 2: Important Instructions

    Thank you for choosing a Thermal Wave Infrared Zone Heating System. This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new heater.
  • Page 3: Specifications

    20. WARNING: To reduce the risk of fire or electric shock, DO NOT use this unit with any solid-state speed control device. 21. Please contact SUNHEAT International for service or for replacement parts for the heater. 22. Connect to properly grounded outlets only.
  • Page 4: Product Diagram

    WARNING: This heater has a voltage rating of 120 volts. The cord has a plug as shown in A. An adapter as shown in C is available for connecting three-blade grounding-type plugs to two-slot receptacles. The grounding lug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box.
  • Page 5 Control Panel 1. Power indication Light:Indicate when the unit connects to power supply. 2. Timer indication light:The light’s on when timer functions. 3. Fan indicator light: The light’s on when cooling fan functions. 4. Signal-receiving window: For receiving remote control signal. 5.
  • Page 6 Remote Control Purifier button: setting purifier on or off Mode button:Used for mode selection Temp up: to make set temperature rise Temp down:to make set temperature decline Heat On/Off button: Powers the display on and off ℃/℉ button: Used for alternating between Fahrenheit and Celsius Timer button: Used for setting timer and adjust time value of timing PREPARATION Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet.
  • Page 7 Turn the heater on by pressing the HEAT ON/OFF button on the control panel or by pressing the HEAT ON/OFF button on the supplied remote control. Turn the heater off by pressing the HEAT ON/OFF button on the control panel or by pressing the HEAT ON/OFF button on the supplied remote control.
  • Page 8 POWER-OFF TIMER Setting the Function Note: The Power-Off-Timer Function will allow for the heater to power OFF after a certain set time, and can only be set while the heater’s display is in the “On” position. Turn the heater to the “On” position. Press the Timer button on the heater’s control panel or the remote.
  • Page 9: Maintenance

    Press Temp Up and Temp Down buttons at the same time for 3 seconds. Locking is complete when you hear a beep. When locked, the functions of the control panel and remote will be locked for use. When you need to unlock it, press Temp Up and Temp Down buttons at the same time for 3 seconds.
  • Page 10: Basic Troubleshooting

    PUSH Battery STORAGE Store the heater in a cool, dry location when not in use. To prevent dust and dirt build-up, use the original packaging to repack the unit. BASIC TROUBLESHOOTING If the heater will not operate, please check the following before seeking repair advice: 1.
  • Page 11: Limited 3 Year Warranty

    Thermal Wave Warranty Service Center or to the address below. All transportation charges are the responsibility of the consumer. A copy of the original receipt must accompany all warranty claims. SUNHEAT International www.sunheat.com 3724 Arch Ave.

Table of Contents