PLEASE SAVE THESE INSTRUCTIONS WARNING: READ THIS OWNER’S MANUAL CAREFULLY BEFORE USE. Thank you for choosing a Thermal Wave by SUNHEAT Infrared Zone Heating System. This owner’s manual will provide you with valuable information necessary for the proper care and maintenance of your new product.
20. WARNING: To reduce the risk of fire or electric shock, DO NOT use this unit with any solid-state speed control device. 21. Please contact SUNHEAT International for service or for replacement parts for the heater. 22. Connect to properly grounded outlets only.
WARNING: This heater has a voltage rating of 120 volts. The cord has a plug as shown in A. An adapter as shown in C is available for connecting three-blade grounding-type plugs to two-slot receptacles. The grounding lug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box.
Page 5
Control Panel 1、Power indication light: Indicates when the unit connects to power supply. 2、Timer indication light:The light’s on when timer is functioning. 3、Fan indicator light: The light’s on when cooling fan is functioning. 4、Signal-receiving window: Receives remote control signal. 5、Digital display:Indicates set room temperature or time value according to the timer. 6、Celsius indicating light 7、High mode indication light: The light’s on when in high mode setting.
Page 6
Remote Control Fan button: For selecting fan mode. Mode button: Used for selecting heater mode. Temp up button: To make set temperature rise. Temp down button: To make set temperature decline. ON/OFF button: Used for power-on or power-off. ℃/℉button : Button for alternating between Fahrenheit and Celsius. Timer button: Used for setting timer and adjust time value of timing.
Page 7
Turn the heater off by pressing the HEAT ON/OFF button on the control panel or by pressing the HEAT ON/OFF button on the supplied remote control. Note: Powering off the heater will stop the heating process only. The fan will continue to blow for approximately 1 more minute to allow for the interior components to cool.
Page 8
3、 POWER-OFF TIMER Setting the Function Note: The Power-Off-Timer Function will allow for the heater to power OFF after a certain set time, and can only be set while the heater’s display is in the “On” position. Turn the heater to the “On” position. Press the Timer button on the heater’s control panel or the remote.
will be locked for use. When you need to unlock it, press Temp Up and Temp Down buttons at the same time for 3 seconds. You will hear a beep. The control panel and remote control will become functional again. 6、...
1) Remove bracket screws (2X) 8. If you do not use the heater for a long time, please take out the remote batteries (to prevent corrosion ) as shown below. Store the remote in a safe place. PUSH Battery STORAGE Store the heater in a cool, dry location when not in use.
Thermal Wave Warranty Service Center or to the address below. All transportation charges are the responsibility of the consumer. A copy of the original receipt must accompany all warranty claims. SUNHEAT International www.sunheat.com 3724 Arch Ave.
Need help?
Do you have a question about the Thermal Wave TW1500 and is the answer not in the manual?
Questions and answers