Smeg LB 1001 User's Book Manual page 16

USING THE WASHING MACHINE
DELAYED START:
The machine is fitted with a delayed start function. This allows the washing machine to be
programmed to start the wash cycle up to 8 hours later. The delay in hours can be selected as
follows: pressing button (I) once will delay the wash for 1 hour, pressing twice will delay the wash
for 2 hours, and so on for a maximum of 8 hours. Then press the START button (L).The button
(I) will light-up signalling that the function has been activated. The machine will wait for the number
of hours set to elapse and then start the wash cycle automatically.
START BUTTON:
Press this button to start the wash cycle. Button (L) will light up to indicate the wash cycle
has started.
PROGRAMMER KNOB "STOP":
The stop function resets the washing machine. If, for any reason, you want to change the wash program
or add more washing to the load during the wash cycle, simply place the programmer knob in position
"STOP" (the "START"
the "START" button.
Warning!! only use this function if strictly necessary and then only if the program to reset has not been running for
more than 3 minutes. Before opening the door after a reset, wait 2 minutes for the locking mechanism to release.
If one of the following buttons is selected, it will light up. If a function button has been pressed by
mistake or is no longer required, the option can be cancelled by simply re-pressing the button.
PREWASH:
Press this button to obtain a short prewash of maximum temperature 40 C
and approximately 10 minutes duration
This function can only be used with "COTTON, SYNTHETIC and DAILY"
programs. Button 3 will light up.
ENERGETIC WASH:
When this button is pressed, the washing machine will run a wash cycle
at the set temperature, though with a longer duration. The button is enabled
for the "COTTON" and "SYNTHETIC" programs.
EXTRARINSE:
The washing machine has been designed to reduce water consumption to
a minimum. In very soft water areas, or in the case where detergent residues
are noticed at the end of the wash cycle, pressing this button will add one
more rinse to the program.
ANTI-CREASE:
When this button is pressed, at the end of the wash cycle, the items loaded
in the washing machine will continue to rotate for a further thirty minutes
to reduce creasing. With this function enabled, the spin speed is 800 rpm.
The function cannot be activated for the "WOOL" program.
NB. The use of this function depends on the type of program selected. Consequently, if the wash program
does not include this function, the button cannot be enabled (see "PROGRAM TABLE").
MONITORING THE WASH:
The figure alongside shows the 4 main functions of a wash cycle: PREWASH
- WASH, RINSE, SPIN, END. During the cycle, each of these functions is
highlighted by a led informing the user what the washing machine is doing at
that moment. After the spin phase, the corresponding led will stay lit for
approximately 2 minutes; this is the time lapse necessary before the door can
be opened. At this point, the "END" led will light-up.
GB
button will flash). Then re-position the knob on the new program and press
OPTIONAL FUNCTIONS
SM1638
8h
4h
2h
1h
L
STOP
O
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
fin