Advertisement
Note: Only channel 1-15 are adjustable when high-bit channel is 0, which means not
allowing the adjustment of high-bit channel 0 and low-bit channel 0 simultaneously.
Installation
1. Position the toggle switch to Splitter Mode on both RX and TX.
2. Connect power to 5V/2A and a monitor to display output on RX.
3. Connect RX and TX by the USB-A data cable to pair.
4. After pairing, connect power to 5V/2A, a monitor for loopback, and a device to input on
TX.
*Troubleshooting guide: If there's no signal on the monitor connected to RX, please
make sure RX and TX (1) are both switched to Splitter mode and (2) have been paired
together.
Splitter Mode Display (1 to 1):
www.hunterbharat.com
www.hunterbharat.com
Advertisement
