Wm Appliance Control Panels; Diagnostic System; Accessing Diagnostics; Quitting The Diagnostics System - Electrolux 6 Series Service Manual

Guide to diagnostics of NEW COLLECTION EWM09312 electronic controls

2 WM APPLIANCE CONTROL PANELS

These are the stylings available at the time of printing of this Service Manual. Others may be developed in
future.
SERIES
6
SERIES
7

3 DIAGNOSTIC SYSTEM

3.1 Accessing diagnostics

The operations listed below must be performed within 7 seconds.
Series 6
Do not start the procedure with the combination buttons pressed
1. Turn the appliance on at the ON/OFF switch
2. Turn the selector dial clockwise to position one.
3. Press the START/PAUSE button and the nearest
option button simultaneously (as shown in the
figure).
Hold the buttons down until the LEDs and symbols
begin to flash in sequence (approx. 3 seconds).
In the first position, the operation of the buttons, of the LEDs and of the groups of symbols shown on the
LCD screen/Display is checked; turn the programme selector dial clockwise to run the diagnostic cycle for
the operation of the various components and to read any alarms (see diagnostic testing on the following
page).
During this phase, if you press any key combination (other than that related to diagnosis), all the
combinations of options stored are deleted (Extra rinse, Buzzer exclusion, etc.).
3.2

Quitting the diagnostics system

→ To exit from diagnostics system, switch the appliance OFF (pushing ON/OFF button).
T.S.-mdm FCPD-dp Quality tb
1. Turn the appliance on at the ON/OFF switch and
the first LED in the right-hand row turns on.
2. Press the START/PAUSE button and the nearest
option button simultaneously (as shown in the
figure).
Hold the buttons down until the LEDs and symbols
begin to flash in sequence (approx. 3 seconds).
7/61
Series 7
599 74 42-27 Rev.00