Control Panel - Appliance With Mechanical Regulation - Smeg FL224APZD Instructions For Use Manual

Table of Contents

Advertisement

Start of fan assisted
Start of fan assisted
cooling
cooling
(control panel 1)
(control panel 1)
Open refrigerator door
Open refrigerator door
alarm
alarm

Control panel - appliance with mechanical regulation

ON/OFF button
ON/OFF button
• In apliances with digital display the indicator fl ashes during the setting
procedure, and the beep signals each change of preset temperature.
When fl ashing stops the fi nal setting is stored in memory.
• When the appliance is switched on, the display (A) will fl ash
for a few seconds – the set value will be indicated. After a
while, the actual or maximum value is indicated. This value
will remain on the display until the actual temperature in the
refrigerator compartment falls below the displayed level.
Fan assisted fast cooling is started by pressing the button (D).
Orange LED is on. Fan eliminates minor temperature differences
between different cabinet spaces, and reduces dew formation on
the interior surface of the appliance.
The alarm sounds if the refrigerator door is left open for more
than 1 minute. When the door is closed again the alarm stops.
The appliance is switched on/off by turning the temperature
selector (see Fig.) to any position from 0 to 7.
The appliance operation is controlled by turning the thermostat
(temperature selecting button) located within the refrigerator
cabinet from the position STOP (0) to the position 7 and back.
Temperature setting
• The higher the position of the temperature selector (towards
position 7) the lower is the temperature (cooler) within the cabinet
of the appliance. Interior temperature in the refrigerator may even
fall below 0°C. Higher position settings are to be used on in case
of recommended low cooling temperature. In case of standard
ambient temperature we recommend the medium setting.
• Change in the ambient temperature affects the temperature of
the appliance, so the position of the temperature selector should
be adjusted accordingly.
• In the STOP (0) position the appliance is switched off (cooling
system is off). However, the appliance is still powered (light bulb
is turned on if you open the refrigerator door).
9

Advertisement

Table of Contents
loading

Table of Contents