pTron Tangent Flex User Manual

Important : pTron 'Tangent Flex' is set at 50% default volume. You can increase the volume through the or through
the connected device.
Button Function:
Button
i. Long press power on/off & for next song
+ ii. Double press for play/pause & answer call or call hang up
iii. Single press for volume increase
i. Long press for previous song
ii. Double press for play/pause & answer call or call hang up
-
iii. Single press for volume decrease
iv. Press three time for redial last number
Charging the Neckband
i. Connect the provided USB type-C charging cable to the neckbands charging port and connect the other end of
the cable to a 5V/1A USB power source
ii. Plug the USB connector of the cable into a USB 5V/1A power source.
iii. The indicator light will blink red while the neckband is getting charged. Depending on the power delivered to
the charging case, the charging case will take approximately 1 to 1.5 hour to completely charge.
iv. The indicator light will turn red to blue when the neckband is fully charged.
Power on/Off
i. To power on: Press and hold the"+" button for 3 seconds until the LED indicator flashes.
ii. To power off: Press and hold the"+" button for 3 seconds until the LED indicator turns off.
Pairing with a Bluetooth Device
i. Make sure the neckband is Turn on and in pairing mode (LED indicator flashing).
ii. On your Bluetooth device, enable Bluetooth and search for available devices.
iii. Select "pTron BT" from the list of available devices to pair.
iv. Once paired successfully, the LED indicator will stop flashing.
Using the Neckband
Music Playback
i. Play/Pause: Press the "+" or "-" button two times.
Tangent Flex - User Guide
Use Picture