Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Fontana Forni CHAR-OVEN
Summary of Contents for Fontana Forni CHAR-OVEN
- Page 1 CHAR OVEN_00 | Pc3 1 maggio 2020...
-
Page 2: Security Lock
CHAR OVEN_00 | Pc3 IMPORTANT: PLEASE FOLLOW THE INSTRUCTIONS BELOW TO AVOID DAMAGES OR ACCIDENTS. DO NOT TRY TO OPEN THE DOOR WITHOUT REMOVING THE SAFETY LOCKS FIRST. If the blocks are not removed the counterweights remain fixed and do not work. - Page 3 CHAR OVEN_00 | Pc3 The oven is delivered with a safety lock that prevents both the door from lifting and the counterweight from coming out of the sliding rails due to the movement of the oven during transport and installation. This safety lock must be removed only after the oven has been put into operation in its final destination and before using it.
- Page 4 CHAR OVEN_00 | Pc3 In the rear part, unscrew the screw that holds the safety hook locked (1) and slide it out so as to release it (2) and allow the counterweight to move along the rail. In this way we have enabled the opening of the upper door (3-4).
- Page 5 CHAR OVEN_00 | Pc3 L’apertura della porta avviene in senso verticale e il sistema a contrappesi permette all’utente di aprire e chiudere con il minimo sforzo agendo sulla maniglia centrale in silicone. 1 maggio 2020...
- Page 6 CHAR OVEN_00 | Pc3 UPPER DOOR CLEANING AND MAINTENANCE. To easily clean the inside of the upper door, follow the steps listed below and pay attention to the various steps to avoid damaging the oven and/or avoiding accidents. First of all open the lower oven door. 1 maggio 2020...
- Page 7 CHAR OVEN_00 | Pc3 By opening the lower door, as shown in the area highlighted in the picture, there are 2 retractable handles hic have a dual function: one for support and the other for safety. While using the oven, the handles must always be completely closed as shown in the photo above.
- Page 8 CHAR OVEN_00 | Pc3 To clean the inside of the door, wait until the oven is cold if used to avoid burns. Slide out both handles until they are fully extended (about 24cm). In this way we ensure the locking of the rails (as in the picture) and in the following stages we avoid the risk of accident or damage to parts of the oven.
- Page 9 CHAR OVEN_00 | Pc3 Once the screw is removed, we can open the door for maintenance. 1 maggio 2020...
- Page 10 CHAR OVEN_00 | Pc3 Pull the handle towards you firmly, in this way the door will open up to lean on the handles allowing you to comfortably reach the inside for cleaning. 1 maggio 2020...
-
Page 11: Locking Screw
CHAR OVEN_00 | Pc3 Once the maintenance/cleaning has been carried out, close the door by performing the operation in reverse. To keep the door in the closed position in the upper right part there is a magnet that ensures closing in position. - Page 12 CHAR OVEN_00 | Pc3 OVEN MODE The oven delivered is already set up for operation in indirect cooking mode. In this way the fire remains separate from the cooking chamber and the fumes pass into the rear of the oven and then go out into the chimney.
- Page 13 CHAR OVEN_00 | Pc3 1 maggio 2020...
- Page 14 CHAR OVEN_00 | Pc3 For ignition, place small/medium sized wood on the grill in small quantities to facilitate better combustion. Add a few pieces to keep the flame alive until achievement of the desired temperature. Avoid overloading the combustion chamber with too much wood to avoid excessive overheating with risk of deformation due to too much heat and/or thermal shock.
-
Page 15: Draft Control
CHAR OVEN_00 | Pc3 We therefore recommend that you turn on the oven empty for the first time without cooking anything to allow any smells to not contaminate the dishes. DRAFT CONTROL Light the fire above the grill as you do in indirect cooking ovens (see scheme below). - Page 16 CHAR OVEN_00 | Pc3 1-REFRACTORY PLATE 2-METAL TOP 3- FIRE GRID 4-ASH COLLECTING DRAWER 1 maggio 2020...
- Page 17 CHAR OVEN_00 | Pc3 The oven is also equipped with an aid to facilitate the draft if there are difficulties in evacuating the fumes in the chimney thanks to a fan for forced draft. Activating the fan with the button on the front panel and turning the register clockwise as shown in the figure below the valve, it is located so that the fan sucks in air from the outside and conveys it to the chimney, forcibly favoring the draft.
- Page 18 CHAR OVEN_00 | Pc3 Still in use in oven mode, it is possible to feed the fire with a flow of fresh air to increase combustion using the second register as in the following figure. This function intercepts part of the air which favors the forced draft of the fumes.
- Page 19 CHAR OVEN_00 | Pc3 1 maggio 2020...
- Page 20 CHAR OVEN_00 | Pc3 BBQ MODE Starting from the indirect cooking oven scheme, remove the refractory griddle at the base of the cooking chamber. Lift up the metal plates by pushing them from the bottom as shown in the figure below and remove them from their seat. 1 maggio 2020...
- Page 21 CHAR OVEN_00 | Pc3 At this point, remove the fire grids from the combustion chamber Rotate them by 180 ° 1 maggio 2020...
- Page 22 CHAR OVEN_00 | Pc3 And put them in place of the metal plates just pulled out The ash drawer remains in its position 1 maggio 2020...
- Page 23 CHAR OVEN_00 | Pc3 1 maggio 2020...
- Page 24 CHAR OVEN_00 | Pc3 Unlike the oven, in this case, the charcoal and the embers must be placed on the grill inside the cooking chamber. Once the embers are heated, you can cook both with the door closed and with the door open. It may happen that during the grilling and over the embers a lot of smoke is generated which could annoy those who cook in front of the bbq if the door is open or fill the cooking chamber if the door is closed.
- Page 25 CHAR OVEN_00 | Pc3 The fan function only guarantees internal suction or the draft of combustion fumes. THE VENTILATED COOKING FUNCTION IS NOT PROVIDED as in traditional ovens. 1 maggio 2020...
Need help?
Do you have a question about the CHAR-OVEN and is the answer not in the manual?
Questions and answers