Teeter MyoTrak Cushion Use Instruction

• DO NOT use product as a replacement for medical advice. Consult with your physician prior to use.
• DO NOT use on sensitive skin, when sores/skin lesions are present or on varicose veins, or if you have muscle,
ligament, tendon or other soft tissue injuries.
• Prolonged use may cause muscle soreness; it is recommended to use in moderation.
• If using as an accessory to the Teeter Inversion Table:
• DO NOT use until you have read and understand the User Guide that accompanies the inversion table and
are already comfortable using the inversion table.
• Use on the inversion table may affect the balance, causing the table to rotate faster. Set the angle tether
and adjust your user settings per the Inversion Table User Guide.
• Use a spotter for the first time until you are comfortable with controlling your rotation.
The MyoTrak Cushion is ergonomically designed to stretch
the cervical spine for improved alignment and massage soft
tissue along the upper back, shoulders and neck for enhanced
circulation and muscle tension relief. Use it to:
• Relax on the floor or any firm surface;
• Enhance your decompression on your Teeter
Inversion Table.
AT TA C H T O I N V E R S I O N TA B L E
• Locate the desired tracks for the MyoTrak Cushion in the
backrest of your inversion table.
• Place cushion on the backrest, then thread both ends of the
nylon strap through the tracks (Figure 1).
• To tighten (Figure 2a & 2b):
• Insert the end of the strap into the center opening of the
buckle from the bottom.
• Loop over the bar and insert the strap down through the
opposite side opening.
• Pull on the end of the strap until the cushion fits snugly on
the backrest.
• To release, pull up on the tab on the buckle and loosen
the strap.
Your inversion table may differ from images shown. Assembly and use of the MyoTrak Cushion remains the same.
MyoTrak
™
WARNING
!
Use Instructions
Cushion
Figure 1
Figure 2a
Figure 2b