Architectural Mailboxes 2541 Mounting Instructions

IMPORTANT! This
mailbox is intended to be
mounted under an eave or
another protected area.
1 Using the guide on the back of these
instructions, mark the wall at the center of
each crosshair. Use a level to ensure a
straight installation (optional).
2 Drill into the wall at each marked location.
Use a 1/4" drill bit for brick or other
masonry wall. Use a 1/16" drill bit for wood
wall.
1/4" masonry bit
- or -
1/16" wood bit
x4
3 Skip this step if installing into wood.
Insert the included plastic anchors into the drilled
holes. Gently tap them in if necessary.
x4
Questions, Comments, Concerns?
www.architecturalmailboxes.com
support@architecturalmailboxes.com
R
Hardware
(included)
x 4, screws
x 4, plastic
anchors
Wall Mount Mailbox | Model 2541
MOUNTING INSTRUCTIONS
Tools
(not included)
One Drill
4 Insert the screws into the drilled holes and
secure with a screwdriver. Hang the mailbox
onto the secured screws using the bottom
eyelet holes on the back of the mailbox.
With the mailbox hanging from the bottom
screws, mark the wall in the center of the
top two mounting holes.
5 Remove the mailbox from the wall and drill
the remaining holes. Insert plastic anchors,
if needed.
x2
6 Replace the mailbox, and secure using the
two remaining screws.
One Phillips Screwdriver
One Drill Bit
1/4" masonry bit or 1/16"
wood bit
Find us on social media!
@archmailboxes
Rev. E © 2020, Architectural Mailboxes, LLC