Related Manuals for BEER TX-246
Summary of Contents for BEER TX-246
- Page 1 Contact grill TX Type TX-246 / TX-247 (single-plate appliance) Type TX-258 / TX-259 (two- plate appliance) Operating instructions Installation & technical data Caution: Always read the instructions before use!
-
Page 2: Table Of Contents
TABLE OF CONTENTS Introduction ..........................4 Welcome to ........................4 Symbols ..........................4 Operating instructions and general notes ................5 Operating instructions ......................5 General information ......................5 Hazard warnings ........................6 Electrical energy ....................... 6 General safety instructions ....................6 Warranty and liability ....................... - Page 3 Subject to technical changes Before installing and operating the appliance, read the operating and installation instructions carefully and follow the instructions contained therein. You are responsible for ensuring that your device is in perfect working order. Due to continuous further development, illustrations, functional steps and technical data may vary slightly.
-
Page 4: Introduction
It must always be available for reference in the vicinity of the appliance. Beer Grill AG accepts no liability or warranty obligations for damage caused by non-compliance with the installation and operating instructions or by improper handling. -
Page 5: Operating Instructions And General Notes
Any modification to the appliance or the use of individual parts and functionally important spare parts that are not original Beer parts, as well as non-compliance with the instructions in the operating instructions, will invalidate the guarantee and exclude any liability claims. -
Page 6: Hazard Warnings
Hazard warnings Electrical energy Attention! In the event of faults in the electrical power supply, switch off the appliance immediately! Work on electrical systems or equipment may only be carried out by an authorised electrician or by instructed persons under the guidance and supervision of a qualified electrician in accordance with the electrotechnical regulations. -
Page 7: Warranty And Liability
Warranty and liability The "General Terms and Conditions" of Beer Grill AG, Allmendstrasse 7, CH-5612 Villmergen, in which the details of the warranty claims are regulated, apply in principle. Warranty claims and liability for personal injury and damage to property are excluded if they are attributable to one or more of the following reasons:... -
Page 8: Technical Data
Cables and plugs External dimension: 400 V / 50Hz 2 m connection cable, 3 PE, 4000 W Without plug TX-246 380 x 500 x 330 mm Max. Rated current Grill surface: Type 15 or CEE 16 359 x 268 mm Weight: 6A CE certification approx. -
Page 9: Transport Of The Devices
Transport of the devices Special care must be taken when transporting the appliance to avoid damage caused by force, careless loading and unloading and impacts. Only the handles provided for this purpose may be used to carry the appliance. Check the delivery immediately upon receipt for completeness and transport damage. In the event of externally recognisable transport damage, do not accept the delivery or only accept it with reservations. -
Page 10: Setting Up The Devices
Setting up the devices Set up Installation may only be carried out by authorised specialists. The appliances must be placed on a level, solid and fireproof surface. TX contact grills are free-standing appliances and must not be installed in recesses. The lateral distance to non-combustible materials or parts of buildings must be at least 10 cm. -
Page 11: Connecting The Devices
Please check that the appliance and accessories are complete. If any parts are missing, please contact our customer service. Connecting the devices Electrical connection Connection and commissioning may only be carried out by qualified personnel. Proceed as follows when connecting the device: + Check whether the mains data relating to voltage, power and frequency match the data on the rating plate of the appliance. - Page 12 Main switch/ on/off changeover switch for bottom heat or top and bottom heat Thermostat (temperature setting) Rotary handle for the spring tension of the cover (closing pressure) Digital timer Lever to straighten the TX contact grill so that products do not run off (only TYPE 247 259) Cast iron plate flat at the bottom Fat collection tray Grill surface below (available in flat and grooved versions)
-
Page 13: Advice For Grilling And Roasting
Caution: Risk of burns! The following parts become very hot during operation, so there is a risk of burns if they are touched: Entire housing Grill plates Frame Fat collection tray As well as any accessories used Advice for grilling and roasting Only when the grill plates have reached the required temperature should they be lightly oiled. -
Page 14: Grill Temperature Settings And Grilling Times
Roasting large pieces (roasts, poultry) For example, the appropriate piece of poultry, whether fresh or frozen, is separated, wrapped in aluminium foil and placed between the hot grill plates. In this case, contrary to the general rule: "The thicker the meat, the lower the heat", you can work with very hot plates so that the grilling process does not take longer than with unwrapped food. - Page 15 Barbecue food Thermostat Min. Sec. position Sausages, minced beef steak, veal head Bratwurst (blanched, cold, warm) 20 - 40 Wienerli, Frankfurter 3 - 4 Cervelat (red sausage) 3 - 6 Minced beef steak, 150 g 3 - 5 German beefsteak (hamburger) 4 - 5 4 △...
-
Page 16: Operating The Multi-Timer
Caution: Risk of burns! Allow the grease to cool down completely! Carefully pull the grease drip tray forwards by the handle. Grasp the grease collection tray with both hands and carefully pull it out completely. Empty grease and residues into a suitable prepared container for proper disposal. - Page 17 Programming To permanently set the time settings, press the Prog button for 1 second. The selection lamp for the current selection position now flashes, signalling that programming mode has been reached. The selection and setting is now carried out in the same way as for the foreground setting, but the time values are now saved in the non- volatile memory after returning to the basic status or changing the selection.
-
Page 18: Accessories
Art. No. 200 270 Cleaning agents: Atomiser filled with Beer Clean (0.5l) ArtNo. 201 004 Grill cleaner Beer Clean (refill canister 10.0l) Art. No. 201 Important Beer Grill AG accepts no liability for damage caused by improper use of the accessories. -
Page 19: Cleaning
10 Cleaning Before cleaning, disconnect the appliance from the power supply (pull out the plug/switch off the main switch provided by the customer). To minimise the cleaning effort, use the barbecue spray (item 201026) as a preventative measure before each grilling session by spraying on a thin layer. -
Page 20: Maintenance
If components are damaged or no longer function properly, the appliance must no longer be used. In this case, the appliance must be repaired by an authorised specialist or by Beer Grill customer service. Before requesting customer service, check the mains cable and fuses and check the following points:... -
Page 21: Waste Disposal
12 Waste disposal The disused appliance must be disposed of at the end of its service life in accordance with national regulations. We recommend that you contact a company specialising in waste disposal or contact the waste disposal department of your local authority. To prevent misuse and the associated risks, render your old appliance unusable before disposing of it.
Need help?
Do you have a question about the TX-246 and is the answer not in the manual?
Questions and answers