Table of Contents
Advertisement
ADJUSTMENT
ADJUSTMENT OF TONEARM LEVER
Set the turntable unit upside down after putting the tonearm
on the arm rest and securing it.
Then, loosen the set screw (w/hex hole) and position the
lever (M14) in such a way that the protrusion of the micro-
switch contacts the foremost end of the lever.
ADJUSTMENT
OF MICRO-SWITCH
Set
the
turntable
unit back
in its normal
position
(the
turntable
platter
at the top).
Loosen
the phillips screw
(see illustration) with a screwdriver and adjust the micro-
switch
position so that the micro-switch will be turned on
when
the tonearm
has moved a little toward the turntable
center (namely, to the mirror of the deck panel).
ADJUSTMENT OF AUTO-RETURN
There
is a shaft
which
is accessible
with
an
ordinary
screwdriver
through
the
hole
below
the tonearm.
(See
illustration at right.)
When the stylus has reached a point
approximately
55mm
from the turntable center, turn the
shaft clockwise
or counterlockwise
and select a position
where it actuates the auto-return.
ADJUSTMENT OF HEADSHELL
ae eid
:
<——
Counterweight
Advertisement
Table of Contents
