Page 3
DISCLAIMERS The information in this manual has been carefully checked and is believed to be accurate. CYP (UK) Ltd assumes no responsibility for any infringements of patents or other rights of third parties which may result from its use. CYP (UK) Ltd assumes no responsibility for any inaccuracies that may be contained in this document.
Page 4
SAFETY PRECAUTIONS Please read all instructions before attempting to unpack, install or operate this equipment and before connecting the power supply. Please keep the following in mind as you unpack and install this equipment: • Always follow basic safety precautions to reduce the risk of fire, electrical shock and injury to persons.
2× Mounting Screws 1× Operation Manual 4. SYSTEM REQUIREMENTS Must be installed into a product with an available compatible CYP Module Slot Personal computer (Windows or macOS) with a USB-C port and plenty of available hard drive space.
5. FEATURES Supports video resolutions up to 4K@60Hz from the product it is installed into USB-C output allows uncompressed video and audio data capture (up to 4K@30Hz, LPCM 2.0) via the connected PC Note: 4K sources with framerates higher than 30Hz are automatically converted to lower framerates which depends on the setting of your PC software.
USB-C Out Port: Connect to a PC or laptop for video capture. 6.2 Card Installation To install this module card into your unit, it must have at least one available CYP Module Slot. Make sure the antistatic procedure is processed before touching the module card.
Page 9
(1) Prior to installation, power the unit completely off. (2) Remove the dummy faceplate that is covering the card module slot by unscrewing both screws. Note: Be sure to store the dummy faceplate, and its screws, somewhere safe, in case you need to use them again later. (3) Align the card with the guiderails to each side of the module slot, and gently slide the module card into the slot until its faceplate is flush with the back of the unit.
6.3 Card Removal (1) Prior to removal, power the unit completely off. (2) Completely unscrew both screws. (3) Gently pull the card straight out of the module slot using the handles on each side. (4) Cover the module slot with a dummy faceplate and tighten it in place using appropriate screws.
Need help?
Do you have a question about the SDM-XT-C and is the answer not in the manual?
Questions and answers