Active ST50 L User Manual page 25

ST50 - ST65 ENGLISH
- Install the lower flange(3), protection cup(2) - (if the lower flange has no
nut protection), tighten the nut(1)anti-clockwise to 30 Nm (Kgm 3.0).
- To lock the nut(1), turn the blade until the hole in the upper flange
corresponds with the hole in the bevel gear, and insert the Allen key (4 mm)
provided.
Mounting the head (2) see fig.10-11.
- Mount the nylon threaded head following the illustrated arrangement:
Upper flange (1) and screw the nylon threaded head anti-clockwise.
Hand-tighten the head anti-clockwise as shown in Fig.10 after inserting the
Allen key (4 mm) into the bevel gear hole.
For your safety, only use original cutting tools.
ACCESSORIES ASSEMBLY VERSION Z MACHINE
Fig.25 - Loosen the lever(1) anti-clockwise, thread the tube(2)into the
sleeve(4)as far as the reference(3) (approx. 40mm), keeping the pin(7)facing
upwards, to facilitate insertion of the shaft(5)into the shaft hub(6), rotate
the tool a little to the right and a little to the left until the tool/tube is inserted
correctly.
Turn the tool into the working position and lock it by means of the lever(1). For
the safety of the operator the tube(2)has a hole(8)where the pin(7)must fit.
ASSEMBLY OF THE EXTENSION (on request and ONLY FOR TOOLS A - B - C)
Extension - machine coupling:
Fig.26 - Loosen the lever counterclockwise(1). Insert the extension tube(2) into
the sleeve(4) to the reference(3) (about 40mm), keeping the pin(12) facing
upwards. Turn the sleeve(10) to the same position as the sleeve(4), and lock it
via the lever(1).
For operator safety, the tube(2) and(8) have a hole(13) where the pin(12) is to
be inserted.
Accessory coupling - extension:
Fig.26 - Loosen the lever(1) anticlockwise. Insert the tube(2)of the extension
into the sleeve(4)up to the mark(3) (approx. 40mm), keeping the pin(12)
facing upwards. Rotate the sleeve(10)to the same position as the sleeve(4)
and lock it with the lever(1).
For the safety of the operator, the tube(2)and(8)have a hole(13)where the
pin(12) must fit.
CAUTION: For the use of accessories A - B - and C see the specific instruction
manual attached to each accessory.
The machine extension (only for accessories A - B and C) must not exceed
1500 mm, otherwise it can be dangerous. Only one extension, either 750mm
or 1500mm, may be used.
HARNESS
Fig.27 - The ergonomic ACTIVE® harness provides exceptional comfort and
enables safe operation. In order to benefit from the advanced technology
applied in this type of machine, it is necessary to correctly adjust the harness
according to the operator's needs.
25