Toro 30486 Operator's Manual page 42

1. Cam
2. Nut and bolt
3. Wing nut
9. After the cam is adjusted, the lever switch needs to
be checked.
10. Check the gap between the control lever and switch
as shown in Figure 56. The gap needs to be between
a 1/16 inch to 3/32 inch (1.6 mm to 2.4 mm).
11. If needed, loosen the screws holding the switch and
adjust the switch.
12. Tighten the screws and install the cover under the
control panel.
Figure 55
4. Turnbuckle
5. Switch screws
1. Right side motion control
lever pivot shown under
controls
2. Right side motion control
lever
Adjusting the Neutral Position for the
Motion Control Levers
Important: Ensure the tracking of the mower is
correct after adjusting the motion control levers.
After adjusting the tracking, the motion control
levers may not align the exactly front to back
(Figure 57).
If the motion control levers do not align front to back,
or the right side control lever does not move easily into
the neutral lock position, adjustment is required. Adjust
each lever and control rod separately.
Note: Adjust the horizontal alignment before the front
to back alignment.
1. After the horizontal alignment is finished, check the
front to back alignment (Figure 57).
42
Figure 56
3. 1/16 inch to 3/32 inch
(1.6 mm to 2.4 mm) gap
needed between switch
and control lever
4. Switch