Table of Contents
Advertisement
•
Freezer compartment temperature can be set in the range from -16°C to -24°C.
•
Each time one of the C1 keys is pressed, the temperature is increased or decreased by 1°C. Three
seconds after the most recent key is pressed, the current setting is automatically stored as the
most recent temperature setting for the freezer compartment of the appliance.
•
Recommended temperature setting is -18°C.
Control unit/display standby mode
INFORMATION!
30 seconds after the most recent key is pressed, the control unit/display switches to standby
mode. All indicators and displays on the control unit will be switched off. If any of the extra
functions is activated, its indicator will remain lit while the appliance is in standby mode, too.
To switch back from the standby mode: briefly press the A or J key or open the refrigerator
compartment door. If any of the extra functions are activated, you may also press the key for activating
or deactivating that extra function in order to wake up the appliance from the standby mode.
Intensive cooling (refrigerator compartment)
INFORMATION!
Use this setting after switching on the appliance for the first time, before cleaning, or before
inserting a large amount of food.
•
While the intensive cooling (super cool) function is activated, freezer compartment temperature
can be set or adjusted as usual.
•
To change the refrigerator compartment temperature while the intensive cooling (super cool)
function is activated, however, the intensive cooling function has to be deactivated first by pressing
the E key.
To deactivate: to deactivate the intensive cooling (super cool) function, press the E key. You will hear
a beep and the super cool indicator will no longer be lit. If the function is not deactivated manually,
it will be deactivated automatically after approximately twelve hours.
22
To activate: to activate the intensive cooling (super cool) function, press
the E key. A beep will be sounded and the super cool indicator will light
up.
Outer segments of the digit on the B display unit will light up in
succession. At first, only the first segment will be lit (see figure above);
then, successive segments will light up in the clockwise direction.
Towards the end of this function's operation, all outer segments on the
B display unit will be lit up.
Advertisement
Table of Contents
