NOTICE DTR 320_290405.qxd
5.2.3.2 VCR
This item is used to select the format of the
output signal for the VCR SCART socket.
- Scroll to the setting you want to change.
The corresponding values are displayed on the
right-hand side of the screen.
- Press the
button to access the available
i
values:
• Video Output: CVBS-PAL, or Y/C. CVBS-
PAL is the default and recommended
setting.
• Easy Record: select the control method
that suits your VCR. Refer to your VCR
user manual.
5.2.3.3 Digital audio output
Select AC3 (digital audio 5.1) only if your
receiver is connected to a Dolby Digital home
entertainment system. For recordings, AC3 will
be switched off automatically.
5.2.3.4 Channel Banner
This item is used to select the channel banner
display duration and transparency.
- Scroll to the setting you want to change.
The corresponding values are displayed on
the right-hand side of the screen.
- Press the
button to access the available
i
values.
29/04/05
14:07
Page 19
5.2.3.5 Volume
This item is used to select the volume level at
start-up.
- Press the
- Press
- Press <OK> to confirm.
5.2.3.6 Remote Control
This item is used to set the remote control
address.
- Press the
- Move to the address you want to select.
- Press <OK> to confirm your selection.
- Proceed as described in paragraph 7.1.
CHANGING THE SETTINGS OF YOUR RECEIVER 19
button to change the level
i
setting.
or
to modify the volume level.
t
y
button to access the available
i
values.
Default address is 039.
If you do not complete the procedure
as described in paragraph 7.1, you will
not be able to control your receiver
using your remote control.