Transport; Storage; Maintenance; Disposal And Recycling - KNOVA KN OSS-2 Manual

TRANSPORT

If you want to move the equipment to a different place,
disconnect the equipment from the power supply and
set it up in the new position you want to use it in.

MAINTENANCE

WARNING
Disconnect the mains plug before
carrying out any maintenance work
Connections and repairs
Connections and repairs of electrical equipment may
only be carried out by an electrician
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Machine data - type plate

DISPOSAL AND RECYCLING

The equipment is supplied in packaging to preven it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equipment
and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
Old device must not be disposed of with household waste!
This symbol indicates that this product must not
be disposed of together with domestic waste
in compliance with the Directive (2012/19/EU)
pertaining to waste electrical and electronic
equipment (WEEE).

TROUBLESHOOTING

The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
PROBLEM
Motor
doesn't start.
Machine gets
slower during work.
Sanding belt
comes off
the drive pulleys.
POSSIBLE CAUSE
ON/OFF switch damaged.
ON/OFF cable damaged.
ON/OFF relay damaged.
Fuse blown.
Motor burnt.
Too much pressure put
on the workpiece.
Belt does not run straight.

STORAGE

Store the device and its accessories in a dark, dry and
frost-proof place that is inaccessible to children.
The optimum storage temperature is between 5 and 30º C.
Cover the electrical tool in order to protect it from dust
and moisture.
Store the operating manual with the electrical tool.
Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consumables.
Wear parts*: grinding medium, Carbon brushes,
sharpening wheel, angle gauge, v-belt
* Not necessarily included in the scope of delivery!
This product must be disposed of at a designated collection
point. This can occur, for example, by handing it in at an
authorised collecting point for the recycling of waste
electrical and electronic equipment. Improper handling
of waste equipment may have negative consequences
for the environment and human health due to potentially
hazardous substances that are often contained in
electrical and electronic equipment.
By properly disposing of this product, you are also
contributing to the effective use of natural resources.
You can obtain information on collection points for waste
equipment from your municipal administration, public waste
disposal authority, an authorised body for the disposal
of waste electrical and electronic equipment or your
waste disposal company.
Replace all damaged parts before
you use your machine again.
Contact your local service centre. Every attempt
to carry out a repair, can be dangerous if it is not done
by skilled personnel.
Reduce the pressure on the workpiece.
Reset the track.
9
HELP