Table of Contents
Advertisement
Dimensions and Clearances
F
G
Unpacking and Removing
Shipping Material
Remove all shipping materials from the washer for
proper operation and inspect it for shipping
damage.
CAUTION
• Failure to remove shipping materials can cause
excessive noise and vibration.
Unpacking Shipping Material
*Some models do not ship with drum support.
Lift the washer off the foam base.
• After removing the carton and shipping
material, lift the washer off the foam base.
• Make sure the plastic drum support
off with the base and is not stuck to the bottom
of the washer.
• If you must lay the washer down to remove the
carton base
, always protect the side of the
b
washer and lay it carefully on its side. Do not lay
the washer on its front or back.
Removing Shipping Material
1
Remove the bolt assemblies.
• Starting with the bottom two shipping bolts
, use the included wrench to fully loosen
c
all 4 shipping bolts by turning them
counterclockwise.
24'' (60 cm)
1/4'' (0.5 cm)
* comes
a
*
• Remove the bolt assemblies (bolts and
retainers) by wiggling them slightly while
pulling them out.
NOTE
• All 4 bolt assemblies must be completely
removed from the unit to avoid product
damage.
• Make sure to remove the entire bolt assembly,
including:
- metal bolt and washer
- rubber damper
- plastic rod
2
Install the hole caps.
• Locate the hole caps
accessory pack or attached to the back of
the washer. Install the caps in the holes left
by the bolt assemblies.
INSTALLATION
11
included in the
d
Advertisement
Table of Contents
