Specifications - Craftsman CMXGPXT1500 Instruction Manual

Electric poly chipper shredder
Table of Contents

Advertisement

AMPERAGE
15A
• Examine extension cord before use. Make sure your extension cord is properly wired and in good condition. Always replace a damaged extension cord or have it repaired by
a qualified person before using it.
• Do not abuse extension cord. Do not pull on the cord to disconnect from receptacle; always disconnect by pulling on plug. Disconnect the extension cord from the receptacle
before disconnecting the product from the extension cord. Protect your extension cords from sharp objects, excessive heat and damp/wet areas.
• Use a separate electrical circuit for your tool. This circuit must not be less than a 12-gauge wire and should be protected with a 15A time-delayed fuse. Before connecting the
motor to the power line, make sure the switch is in the OFF position and the electric current is rated the same as the current stamped on the motor nameplate. Running at a
lower voltage will damage the motor.

SPECIFICATIONS

Model Number
Motor
Maximum Speed
Recommended Material Diameter
Maximum Material Diameter
Weight
Product Dimensions
UNPACKING & TRANSPORTATION
WARNING! Do not plug in or turn on the tool until it is fully assembled according to the instructions. Failure to follow the safety instructions may result in serious personal injury.
UNPACKING
With the help of an additional person, carefully remove the shredder from the packaging. Make sure to take out all contents and accessories. Do not discard the packaging until
everything is removed. Check the packing list below to make sure you have all of the parts and accessories. If any part is missing or broken, please contact our customer service
at 1-888-331-4569 (M-F 8-5 PST).
PACKING LIST
Shredder
1pc
Wheel Axle
Bushing
1pc
2pcs
TRANSPORTING
Use the handle and tilt the shredder to pull it with the wheels. Never carry the tool by its guards or its accessories.
REQUIRED GAUGE FOR EXTENSION CORDS
25 ft.
14 gauge
Support Leg
Push Stick
1pc
Wheel
Nylon Lock
2pcs
50 ft.
12 gauge
CMXGPXT1500
120V AC, 60Hz, 15A
4600 RPM
0 to 1 inch (0 to 25.4 mm)
1-1/2 inches (38 mm)
26.5 pounds
25.6 x 16.5 x 12.6 inches
Collection Bag
1pc
1pc
Wheel Side
Nut M6
Cover
2pcs
2pcs
100 ft.
150 ft.
Not Recommended by UL
Screw ST4.8x19
2pcs
Flat Washer
Ø5
2pcs
10/13mm
Wrench
2pcs
Lock Washer
Ø5
2pcs
Allen Wrench
1pc
5

Advertisement

Table of Contents
loading

Table of Contents