Advertisement
KT-1100D
DISASSEMBLY FOR REPAIR
@ Remove the 6 screws on the metallic cabinet.
@ Remove the metallic cabinet in the direction of the arrow.
@ Loosen halfway the set screw of slotted head on the
knob, then remove the knob from the front panel.
@ Remove the 5 screws on the front panel.
@ Remove the front panel in the direction of the arrow.
@ Remove
2 push rivets retaining the escutcheon to the
sub-panel.
@ Remove the screw on the escutcheon.
© Remove the escutcheon in the direction of the arrow.
@ Remove the 4 screws
on the sub-panel (front side: 2,
lower side: 2).
@ Remove the 2 screws at the sub-pane! on the bottom
plate,
@® Pull out the sub-panel slightly toward the front.
@ Remove the 2 screws on the Quieting contro! unit.
@® Remove the screw on the Sub-unit (X13-5422-72) (D/5),
then remove the Sub-unit (X 13-) (D/5).
@ Remove 3 push rivets retaining the Sub-unit (X13-) (A/5)
to the sub-panel.
@ Remove the Sub-unit (X13-) (A/5) in the direction of the
arrow.
® Loosen halfway the 2 screws at the rear side on the bot-
tom plate.
@ Remove the 2 screws at the front side on the bottom
plate.
® When removing the bottom plate only, also remove the 2
screws on the front side.
@® Remove the bottom plate.
@ Remove the 7 screws retaining the right frame (4 on the
tuner unit, 2 on the rear panel and
1 screw from the
frame at the bottom of the board).
@ Pull out the right frame slightly toward the front and re-
move it.
Advertisement
