Kenwood KRC-705 Service Manual page 13

Set the controls and switches as follows.
BALANCE center position
:center position FADER
ITEM
BASS
INPUT SETTINGS
:center position
TREBLE _:center position
KRC-705/759R/RY/785/805/859C
ICY/RIRY WIWY/885W/PS955
ADJUSTMENT
OUTPUT
SETTINGS
TUNER
(RECEIVER)
SETTINGS
LOUD :OFF DOLBY NR :OFF
METAL :OFF
ALIGNMENT
POINTS
ALIGN FOR
SECTION
SEPARATION
(NARROW)
for Europe
(K21) model.*
(C)
98.1MHz
1kHz, + 40kHz dev
Pilot: + 6.0kHz dev
Selector:L or R
60dB U (ANT input)
TEST MODE:ON
| (Forced Narrow)
FM 98.1MHz
Adjust it so that the
crosstalk from L to R and R
to L become minimum.
SEPARATION
(NARROW)
for K or M
(K2I) model.*
4
(C)
98.1MHz
1kHz, £67.5kHz dev
Pilot: 7.5kHz dev
Selector:L or R
60dB u (ANT input)
TEST MODE:ON
(Forced Narrow)
FM 98.1MHz
Adjust it so that the
crosstalk from L to R and R
to L become minimum.
(C)
98.1MHz
0 dev
35dB U (ANT input)
SECTION
SEEK STOP
LEVEL
(D)
990 kHz
0% mod
35dB U (ANT input)
TEST MODE: ON
FM
98.1MHz
TEST MODE: ON
AM
Preset "1" key,
and preset "6"
key
press and hold preset "6"
key for a few seconds.
"ADJ OK" is displayed if the
adjustment is OK and "ADJ
NG" is displayed if it is not
good.
1
Preset "1" key,
and preset "6"
key
t.
While holding preset "1" key,
While holding preset "1" key,
press and hold preset "6"
key for a few seconds.
"ADJ OK" is displayed if the
adjustment is OK and "ADJ
NG" is displayed if it is not
good.
SSETTE DECK SECTION
AZIMUTH
TCC-153
10kHz
(B)
TAPE PLAY
Head Azimuth
Screw
Adjust the azimuth for each
Lch/Rch or FWD/RVS
becomes maximum
PLAY BACK
LEVEL
TEST MODE : ON
(Forced Narrow)
TCC-130
Connect an
AC voltmeter
to CN2
TAPE PLAY
While holding the "FM" key and preset "6" key, reset the unit.
Hold down the "Tl" key for 2 second. "TEXT" goes ON.
Press preset "6" key. "NR" goes OFF.
VRt (L)
VR2 (R)
(X14)
300mV
*Europe (K2!) model : KRC-PS959R/RY, KRC-859R/RY, KRC-859C/CY, KRC-859W/WY, KRC-759R/RY
*K or M (K2I) model : KRC-985R
1