Table of Contents
Advertisement
MAINTENANCE
Care and Cleaning
Surface Maintenance
Periodically clean the surface of the hood with hot
soapy water and a clean cotton cloth. Do not use
corrosive or abrasive detergent, or steel wool/
scouring pads which will scratch and damage the
surface. Do not use products containing chlorine
bleach or citrus-based cleaners.
For heavier soil use a liquid degreaser.
After cleaning, you may use non-abrasive stainless
steel polish or cleaners to polish and buff out the
stainless luster and grain. Using a clean microfiber
or cotton cloth, scrub lightly and with the grain.
Aluminum Mesh Filters
The aluminum mesh filters installed by the factory
are intended to filter out residue and grease from
cooking. They don't need to be replaced on a
regular basis, as long as they are kept clean.
Remove and clean the filters by hand or in a
dishwasher on low heat. If the filters are heavily
soiled, spray them with a degreasing detergent
and leave them to soak.
Dry filters and re-install before using hood.
Removing Mesh Filters
1
Push the handle on the filter toward the back
of the range hood.
2
Pivot the front of the filter down and pull the
filter forward to remove it.
• To reassemble the filter, insert the back of
the filter first and then lift the filter up into
place.
Checking Max CFM Level
1
With the hood off, press and hold the power
button for three seconds. The indicator lights
will light up to show the maximum CFM level
of the hood.
• 5 indicator lights: default max. CFM (600)
• 4 indicator lights: max. 390 CFM
• 3 indicator lights: max. 290 CFM
2
The number of fan speed settings depends on
the max CFM setting.
390 CFM = max. 4 speeds and 290 CFM = max.
3 speeds
MAINTENANCE
11
Advertisement
Table of Contents
