Table of Contents
Advertisement
Connecting Devices
USB Drive
1. Load a USB drive into the USB Port (32GB maximum).
2. Press the Source button to switch to USB Mode.The display will show the total number of tracks on the USB
drive.
3. Press the PlayIPause button to begin playing. Use the controls on the remote or the under cabinet music
system to pause, adjust volume, etc.
Programming the USB Drive
The unit can be programmed to up to
99
tracks in the order you wish.
1. Please make sure the unit i s stopped and in USB mode.
2. Press the Prog button, the Prog indicator will flash and the display will show "PO1
."
3. Press the SkipITune buttons to select the desired audio tracks. Press the Prog button to confirm the selection.
4. The display will advance to "P02," repeat step 3, up to a maximum of 99 tracks. When the maximum of 99 tracks
have been programmed the display will read "FUC' to indicate the program l i s t i s full.
5. When you have completed programming, press the PlayIPause button to begin the program.The tracks will
now play in the designated order. In order to cancel the programming press the Stop button twice.
USB Repeat Mode
With the repeat feature you can choose to repeat one song, a folder or repeat all tracks.
To repeat a track press the Repeat button once.The display will show
"
rn
ll'indicating the unit will begin
replaying the current track.
Press the Repeat button again to repeat a folder, the display will show
"
r )
FOLDER.
"
Note: If there is no
folder this function cannot be selected.
Press the Repeat button again to repeat all, the display will show "
0
ALL.
"
To cancel the repeat function, press the Repeat button until the repeat indicator on the display turns off.
Line In (3.5mm Audio Input)
Required: 3.5 mm audio input cable (not included).
I I
I I
1. Press the Power button to power on the under cabinet
1 1
1 I
music system.
I I I
2.
Connect a 3.5mm audio cable to the Line In Input on
Pr"-'
the side of the under cabinet music system and the
a
audio outputlheadphone jack on an audio device.
3. Press the Source button to switch to Line in Mode.
4.
Use the controls on the connected device to play your
audio through the under cabinet music system.
Advertisement
Table of Contents
