Tiger APT-0100 Original Instruction Manual page 5

Then fully tighten the locking handle so that the adjusting screw cannot turn. Failure to attach the trolley correctly could result
in serious injury to persons or damage to equipment. Check the trolley is of the correct profile and size, or correctly adjusted,
for the beam width and that it seats correctly on the beam flange. There should be no other contact between the beam and the
trolley. Ensure the beam trolley is strong enough for the full load that will be imposed. Ensure the lifting appliance is
compatible with the trolley and that hooks or other attachments fit freely into the shackle of the trolley.
Check the runway track/beam is level, has an even running surface and is fitted with positive end stops which engage with the
trolley frame or wheel treads.
The trolley must be placed directly over the centre of gravity of the load. Under no circumstances must they be obliquely side
loaded as this will cause them to tip, resulting in damage to the track or the trolley becoming detached from the track and
falling.
For plain trolleys, push rather than pull suspended loads.
For geared trolleys the trolley is moved along the beam by turning the hand chain.
Always transport the load in the horizontal direction slowly, carefully and close to the ground, taking care to avoid swinging the
load.
Before removing it from a beam, make sure there is no load on the trolley. Undo the locking handle by turning it clockwise
then unscrew the adjusting screw anti-clockwise until the trolley is open sufficiently to be removed from the beam.
! WARNING
Always store and handle trolleys correctly.
Always inspect trolleys, blocks and accessories before use and before placing into storage.
Always ensure the wheel profile is suitable for the track.
Always check the trolley width is correctly set for the track.
Always ensure the track is fitted with positive end stops.
Always push rather than pull loads suspended on push/pull trolleys.
Never use defective trolleys, blocks or accessories.
Never expose trolleys to chemicals, particularly acids, without consulting the supplier.
Never expose a trolley directly to the elements, water spray, steam etc without consulting the supplier.
Never use a trolley with chipped or otherwise damaged wheel flanges.
Never obliquely side load a trolley.
Never use trolleys which are unidentified or uncertified for lifting applications.
Never replace bolts, shackles etc without consulting the supplier or an authorised repairer.
Never throw or drop trolleys.
Unit 1, Greensfield Industrial Estate,
Willowburn Avenue,
ALNWICK, NE66 2DG
D =Maximum gap
Product Code Capacity(tonne)
APT-0100/AGT-0100
APT-0200/AGT-0200
APT-0300/AGT-0300
APT-0600/AGT-0600
APT-1000/AGT-1000 10.0
D (Max.)
1.0 3mm
2.0 3mm
3.0 3mm
6.0 3mm
5mm
www.tigerlifting.com
Page 4 of 18
Manual Tiger APT-AGT En 201811 v2.2