Advertisement
OPERATING INSTRUCTIONS
1. Securely solder the appropriate pins of the LED with LED connection contacts (1).
Note! Contact marked with "LED +" must be connected to the appropriate pin of an LED
(marked with a red dot). Improper connection may cause LED damage.
Note! LED case must be electrically isolated from the ground.
2. If you use LMSNT SDM synchronous detector, connect the mD-1c minidriver's
synchronization output contacts (2) with synchronization input terminal block.
SDM
synchronous
detector
3. If necessary, make all the connections of other boards (synchronous detector etc.)
following the appropriate instructions manuals. Before turning them on check the
required connections and modes:
Synchronous detector:
● Photodiode input connection
● Preamplifier power output connection
● Averaging time and signal gain selection
● External signal observing device connection
4. Connect 5V stabilised power supply to the power input (3).
10, A, Kurchatova str., 1N, St-Petersburg, 194223, Russia
synchronisation
synchronisation
input terminal
output contacts
block
LED Microsensor NT, LLC
● info@lmsnt.com ● www.lmsnt.com
mD-1p minidriver
5
Advertisement
