Table of Contents
Advertisement
SERVICE AND ADJUSTME
anveway.
fViake sure tires are properly Inflated (See
HO DUG $ oP EGIF"IC/\ FfQIMo ori ps.
0
© 3 of tills manual^.
it
iires are over or untierinfleted, you will not properly adjust
your mower.
i u-wiUt ftujuo i men i (bee Mgs.
10
anu s
9
)
9
Raise mower to its highest position.
®
At the midpoint of both sides of mower, measure height
from bottom edge of mowerto ground. Distance
"/Von
both sides of mower should be the same or within
1
/
4
"
of each other.
*
If adjustment is necessary, make adjustment on one
side of mower only
•
To raise one side of mower, tighten lift link adjustment
nut on that side.
•
To lower one side of mower, loosen lift link adjustment
nut on that side.
NOTE: Three full turns of adjustment nut will change
mower height about
1
/
8
".
*
Recheck measurements after adjusting.
(o)
THE FOL
NECESSA
EQUALLY
To obtain the best cutting results, the mower nousne
1
/
2
" lower than the rear when the mower is in its highest
position.
Check adjustment on right side of tractor. Measure dis¬
tance 'D directly in tront and behind the manGrei at
Dottosn
edge of mower housing as shewn.
8
Before making any necessary adjustments, check that
both front links are equal in lenqth. Be i
> -
approximately 10-3/8".
®
If links are not equal in length, adjust one link to same
length as other link.
*»
To lower front of mower loosen nut "E" on both front
links an equal number of turns.
9
When distance "D" is 1/8" to 1/2" lower at front than
rear, tighten nuts "F" against trunnion on both front
links.
•
To raise front of mower, loosen nut "F" from trunnior
on
both front links. Tighten nut "E" on both front links an
equal number of turns.
®
When distance "D" is 1/8" to 1/2" lower at front than
rear, tighten nut "F" against trunnion on both front links.
*
Recheck side-to-side adjustment.
Advertisement
Table of Contents
