Advertisement
Quick Links
English
1. Technical specifications
Standards
1 LAN port UTP fast Ethernet RJ45 10/100Mbps
Network Interfaces
1 WAN port UTP fast Ethernet RJ45 10/100Mbps
Signaling protocol
USB Interface
VoIP Channels
Up to 30 channels (10 channels per ICIP30 Codec
board/licenses released on the iCIP hardware key)
Voice coding
G.723, G.726-16, G.726-24, G.726-32, G.726-40
LEDs
Important:
» For this card to function correctly, the following PBX firmware version is
required: 3.12.xx (or higher).
» To use IP extensions and trunks, it is necessary to purchase the ICIP 30
Codec Card and the respective licenses (hardware key).
» Installation, configuration and technical support must only be carried out by
professionals trained for this product.
For more information, see the ICIP card manual available on the website
www.intelbras.com/en.
User's guide
ICIP 30 board
IEEE 802.3 Ethernet 10-BASE T
IEEE 802.3 Nway Auto Negotiation
IEEE 802.3u Fast Ethernet 100BASE-TX
IEEE 802.1Q tagged VLAN
IEEE 802.1p layer2/CoS Traffic Priority
IEEE 802.3ac VLAN tagging
SIP 2.0 / SIP Intelbras
1 USB host type A port
Compatible with USB 1.1/2.0
G711 PCM (A/u-law) up to 64 Kbps
G729 AB CS- ACELP up to 8 Kbps
GSM Full Rate 6.10 up to 13.2 Kbps
(ADPCM)
System status indicators and codecs
2. Product
The product solution that allows access to voice signal transmission
technology over the Internet or a private network is made up of the following:
» ICIP 30 base board: responsible for processing network information, ac-
cess protocols and network connections
» customer and internet;
» ICIP 30 codec board: responsible for the VoIP channels available on the
ICIP 30 base board and UnniTI Centrals, and for processing voice signals
and converting them into data packets within the network. Each codec card
enables 10 VoIP channels.
» Hardware Key with extension licenses and IP trunks.
2.1. ICIP 30 base board
ICIP 30 base board
Connection
positions
ICIP 30 codec
board (1 to 3)
ICIP 30 codec board
ICIP : IP Communication Interface
2.2. ICIP 30 codec board connection positions (1 to 3)
Fixing to the frame
LAN
USB ports
Hardware key
USB - D
1
WAN
LEDs codec1 to codec3
2
Status LED
3
Advertisement
Related Manuals for Intelbras ICIP 30
Summary of Contents for Intelbras ICIP 30
- Page 1 » For this card to function correctly, the following PBX firmware version is required: 3.12.xx (or higher). » To use IP extensions and trunks, it is necessary to purchase the ICIP 30 Codec Card and the respective licenses (hardware key).
- Page 2 2. The installation of the product shall be executed in accordance with the Product Manual 4. Stably support the ICIP 30 base plate on the surface and insert the ICIP and/or Installation Guide. If your product requires the installation and configuration 30 codec card(s) into the available positions, following the diagram below;...
Need help?
Do you have a question about the ICIP 30 and is the answer not in the manual?
Questions and answers