Table of Contents
Advertisement
*3 NOTE: (When AWB adjustment)
• After change to WB adjustment mode for service with software, the adjustment is executed.
After adjusting the AWB adjustment, to cancel the WB adjustment mode for service.
• Refer to the adjustment method in the adjustment software for details.
*4 NOTE: (About the G sensor adjustment)
• Offset adjustment for built in tilt sensor display.
• Refer to the adjustment method in the adjustment software for details.
*5 NOTE: (About Front-Mount Unit adjustment data writing)
• After exchange Front-Mount Unit for service, write data on the label of body cap.
• Label data doesn't have the electronic 1st curtain shutter adjustment value.
• Refer to the adjustment method in the adjustment software for details.
*6 NOTE: (About the electronic 1st curtain shutter adjustment)
• This model adopted electronic 1st curtain shutter and mechanical 2nd curtain shutter for miniaturization.
• Use a collimator for shutter adjustment (RFKZ0630) to make parallel light.
• Refer to the adjustment method in the adjustment software for details.
About the 3D interchangeable lens (H-FT012) correspondence
This unit has no special structure (circuit or part) for the 3D interchangeable lens correspondence, only by software is processed
the 3D interchangeable lens correspondence.
Therefore, if taken with other lenses as usual, the 3D interchangeable lens is no problem for operation.
58
Advertisement
Table of Contents
