Table of Contents
Advertisement
3.2.5 Splitter Cable Labels Identifying the 2 QSFP56 Tails
3.3 Regulatory Compliance and Classification
The laser module is classified as class I according to IEC 60825-1, IEC 60825-2 and 21 CFR 1040
(CDRH).
•
Safety: CB, cTUVus, CE
•
EMC: CE, FCC, ICES, RCM, VCCI
Ask your NVIDIA FAE for a zip file of the certifications for this product.
3.4 FCC Class A Notice
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
3.5 Handling Precautions and Electrostatic Discharge
(ESD)
The MFA7U10 is compatible with ESD levels in typical data center operating environments and
certified in accordance with the standards listed in the Regulatory Compliance Section. The product
is shipped with protective caps on its connectors to protect it until the time of installation. In
normal handling and operation of high-speed cables and optical transceivers, ESD is of concern
during insertion into the QSFP cage of the server/switch. Hence, standard ESD handling precautions
must be observed. These include use of grounded wrist/shoe straps and ESD floor wherever a cable/
transceiver is extracted/inserted. Electrostatic discharges to the exterior of the host equipment
chassis after installation are subject to system level ESD requirements.
(sample illustration)
17
Advertisement
Table of Contents
