Table of Contents
Advertisement
LUBRICATION GUIDE
5. Transmission oil level
and fill tube (1810,
1811 and 1812 Tractors Only)
6. Drive shaft bushing
(1806 Tractor only)
—After Every 30 Hours of Operation
Check the oil with the engine stopped. Keep the lubricant up to
"FULL" mark on dipstick (6).
NOTE: Transmission oil level and fill tube also services the follow¬
ing.
1. Hydrostatic transmission
2. Rear axle
3. Hydraulic lift system (1811,1812)
4. Front hydraulic outlets
(1812 Only)
Two or three strokes of the lubricator using 251H EP grease or
equivalent No. 2 multi-purpose lithium grease.
—After Every 50 Hours of Operation
7. Engine oil drain plug and oil filter
While the engine oil is warm, rerTX)ve the drain plug and oil filter (5).
and drain all of the oil from the crankcase and oil filter lines. Replace
the drain plug.
Refer to "MAINTENANCE," "FILLING THE
CRANKCASE" & "OIL FILTER" for proper oil filling procedure.
Refer to "LUBRICATION TABLE" for the proper quantity and viscos¬
ity to use.
8. Transmission oil filter
(1810.1811,and1812
Tractors Only)
NOTE: After the first 50 hours only, remove the transmission oil filter
and replace with a new filter. Refer to "MAINTENANCE." Change
the transmission oil filter every 100 hours of operation thereafter.
9. Transmission oil filter
(1810,1811, and 1812
Tractors Only)
Speed Control Linkage
10. Cam plates
(1810,1811, and 1812
Tractors Only)
Transmission
(1806 Tractor Only)
11. Oil level and filler plug
12. Oil drain plug
Creeper drive housing
(1806 Tractor Only)
13. Level plug
14. Breather and filler plug
15. Drain plug
16. Steering gear housing
Miscellaneous
Brake pedal shaft
—Every 100 Hours of Operation
Change the transmission oil filter and replace with a new filter. Refer
to "MAINTENANCE."
Once a year, apply a small anxjunt of 251H EP grease or equivalent
No. 2 multi-purpose lithium grease In the slots.
Check the oil level at the beginning and end of each season. Keep
the lubricant up to "FULL" on dipstick.
Check the oil level at the beginning and end of each season.
Every 100 hours of yearly use 251H EP grease or equivalent No. 2
multi-purpose lithium grease. Apply two strokes with lubricator.
Lubricate the brake pedal shaft and linkage with eight or ten drops of
engine oil.
■^NOTE
Lubrication information for optional equipment may be found in the manual which is included with the
specific piece of optional equipment.
34
Advertisement
Table of Contents
