Dormakaba ALVARADO Quick Queue Installation Instructions

Quick Queue Retractable Belt Wall Mount - Installation Instructions
Installers and/or Store Personnel must provide this document to the manager or person responsible
for the maintenance and use of the product. Read the Installation Instructions completely before
NOTICE
installation of the product. If there are any questions, call Alvarado at (909) 591-8431 or toll free at
(800) 423-4143, Monday through Friday, 6:00 AM to 4:30 PM PST.
Materials Enclosed:
1. Bell Retractor
2. Wall Mount
3. Receiver Mount
Follow the Instructions to Assemble a Quick Queue Wall Mount:
3. Wall
Mount
(
4 Holes)
4. Wall Plug (x6)
FIGURE 1 – Quick Queue Wall Mount Components.
1. Mark the desired locations for drilling and drill as necessary to
secure the Wall Plugs flush to the wall.
2. Secure the Wall Mount (with the Locking Tab on top) to a
sturdy wall using the Wall Plugs (4) and Screws (4) provided.
3. Secure the Receiver Mount (with the grooves on top) to a
sturdy wall using the Wall Plugs (2) and Screws (2) provided.
4. Secure the Belt Retractor to the Wall Mount by sliding the
desired receiver up into the Wall Mount until the Locking Tab
'clicks' as shown in FIGURE 2A.
5. Extend the belt and slide the belt end into the Receiver Mount
fully as shown in FIGURE 2B.
Storing the Quick Queue Wall Mount Away:
When not in use, the Belt Retractor may be stored away.
1. Retract the belt by sliding the belt end upwards and walk the
belt end completely back to the Belt Retractor.
2. Release the Locking Tab on the Wall Mount and slide the Belt
Retractor down and away from the Wall Mount.
4. Wall Plug (x6)
5. Screw (x6)
1. Quick Queue
Belt Retractor
5. Screw (x6)
For Assistance: support@alvaradomfg.com +1 (909) 591-8431
Tools Required:
• Phillips Screwdriver
• Hand Held Drill
2. Receiver
Mount
(2 Holes)
FIGURE 2A – Attaching to the Wall Mount.
Belt
FIGURE 2B – Attaching to the Receiver Mount.
• Pencil
Locking Tab
Wall Mount
Quick Queue
Belt Retractor
Receiver
Mount
PUD3047R2-0