Related Manuals for Alvarado IntraQ
Summary of Contents for Alvarado IntraQ
- Page 1 IntraQ Pedestal Guide PUD4131R4-0 Version 3.1 Alvarado Manufacturing Company, Inc. 12660 Colony Street, Chino, CA 91710 Telephone: (909) 591-8431 Fax: (909) 628-1403 support@alvaradomfg.com www.alvaradomfg.com PUD4131R4-0...
-
Page 2: Table Of Contents
IntraQ Pedestals Guide Version 3.0 Contents Preface..................................3 Document Overview..............................3 Support..................................3 Uncrating the Pedestal..............................4 Tools Required................................4 Procedure................................. 4 Assembling the Pedestal.............................. 5 Tools Required................................5 Procedure................................. 5 Basic Functionality Test. -
Page 3: Preface
IntraQ Pedestals Guide Version 3.0 Preface Document Overview This document describes how to set up a battery-powered portable Alvarado IntraQ pedestal for first-time use. Support Contact Alvarado’s Entertainment Support department for any questions or comments you have about this guide or the processes it describes. -
Page 4: Uncrating The Pedestal
2. Use the drill to remove the screws securing the lid to the crate. Each crate can hold a maximum of three (3) pedestals, including the pedestal base, the power supply box, and the IntraQ head box as shown below. -
Page 5: Assembling The Pedestal
IntraQ Pedestals Guide Version 3.0 Assembling the Pedestal The pedestals are shipped in two pieces: the pedestal base and the IntraQ head. Follow the directions below to attach the head to the pedestal base. Tools Required • Size 1/8” hex key •... - Page 6 IntraQ Pedestals Guide Version 3.0 3. Connect the Neutrik connector to the back of the IntraQ head. 4. Verify the power cable plugging into the bottom of the battery is securely connected. 5. Verify the battery power switch (located under the battery) is set to on.
-
Page 7: Basic Functionality Test
IntraQ Pedestals Guide Version 3.0 Basic Functionality Test After setting up the pedestal, press the recessed power button and verify the IntraQ powers on. If it does not power on, check the following items. Recessed power button • Verify the power cable is plugged into the back of the IntraQ head. -
Page 8: Battery Operations
IntraQ Pedestals Guide Version 3.0 Battery Operations Items Required • Battery key • Replacement battery Checking Battery Charge Level Press the gray charge level display button on the battery to display the current charge level of the battery. A new, fully charged battery should be able to allow continuous pedestal operation for up to 18 hours. -
Page 9: Charging The Battery
IntraQ Pedestals Guide Version 3.0 Charging the Battery The charger is in the power supply box. It should take about three hours to fully charge a new battery. 1. Plug the charger into power. 2. Connect the socket to the battery’s charging port. -
Page 10: Removing/Installing The Battery
IntraQ Pedestals Guide Version 3.0 Removing/Installing the Battery To remove the battery: 1. Press the button on the connector to separate it. Each half of the connector is keyed, so it will only reattach one way when you replace the battery. - Page 11 IntraQ Pedestals Guide Version 3.0 To remove the battery: 1. Place the bottom of the battery in the frame. The cutout section of the top of the battery should be facing the pedestal. 2. Tilt the top of the battery toward the pedestal until the locking latch clicks.
-
Page 12: Using The Removable Dolly
1. Tilt the dolly up and slide the tab into the guide on the baseplate. 2. Lean the IntraQ pedestal forward so the back of the baseplate is about half an inch off the floor. 3. Tilt the dolly down so the groove in the dolly fits over the baseplate. -
Page 13: Removing The Dolly
IntraQ Pedestals Guide Version 3.0 4. Use the handle on the pedestal base to lean the IntraQ pedestal back onto the dolly’s wheels and push/pull it to its desired location. Handle Removing the Dolly 1. Lean the IntraQ pedestal forward so the dolly’s wheels are off the ground. -
Page 14: Revision History
IntraQ Pedestals Guide Version 3.0 Revision History Revision Date Author Revision History/Description 9/21/2017 D Bohannon Original Document 5/1/2019 D Bohannon Updated for IntraQ hardware changes. 9/4/2020 D Bohannon Updated images to V3. Added information about quick-connect cable. 5/10/2021 D Bohannon Minor edits. - Page 15 12660 Colony Street, Chino, CA 91710 Telephone: (909) 591-8431 Fax: (909) 628-1403 support@alvaradomfg.com www.alvaradomfg.com © 2021 Alvarado Manufacturing Company, Inc. This work may not be reproduced, published or redistributed, in whole or in part, without the express prior written permission of Alvarado.
Need help?
Do you have a question about the IntraQ and is the answer not in the manual?
Questions and answers