Table of Contents
Advertisement
*Depending on the network conditions, user
settings, method of use, etc the actual results
may differ.
Keeping the charger plugged to the mobile
phone when the battery is fully charged will not
damage the battery. The only way to turn off
the charger is to unplug it, so it is advisable to
use an easily accessible power socket.
If you do not intend to use your phone for
several days, we recommend that you remove
the battery.
You can use the phone while it is charging. If
the battery is completely flat, the battery icon
will only reappear after a few minutes of
charging.
Insert a micro SD card
1. Lift up the micro SD card cover on the left-
hand side of your phone as shown below. If
held properly, the card's gold contacts will be
facing upwards.
10
2. Gently slip the card into the micro SD card slot
and press it down until the card locks into
place.
To remove the micro SD card, push down the
card into its slot and release it. The card will
spring out of the slot.
The maximum capacity of micro-SD that X500
can support is up to 2GB.
Setting hotkeys
You can configure the numeric keys 2 - 9, +, -, <,
>, L and R to access your favorite features. Once
they have been set, you can simply long press the
numeric key to access the corresponding features.
Majority of the hotkeys have been preset and
configured. To check the hotkey settings, go to
Settings
Getting Started
Advertisement
Table of Contents
