Advertisement
Assembly Instructions
A. Table Installation
1.
Remove all three table mounting set screws from the table mounting block (Fig. 1).
2.
Loosen and remove the table alignment screw and wingnut located on the front of the
cutting table blade slot (Fig. 2).
3.
Position cutting table with the slot opening directly behind the blade. Carefully slide the
table forward so the blade travels through the slot in the table.
4.
Once properly positioned, secure in place with the table mounting set screws and the
table alignment screw and wingnut (Fig. 3).
B. Starting and Stopping Saw
1.
The power switch is located on the left side of the band saw. Insure the power switch is
in the OFF position before plugging the DL7000 (Fig. 8) into a power source.
2.
To start the saw make sure wrenches and materials to be cut are not touching the blade.
3.
Press the rocker switch up into the ON position.
4.
To turn the saw OFF, press the rocker switch down.
C. Water System
1.
Place the water reservoir on a solid level work surface. Position reservoir underneath
the lip of the saw located on the right side of the base (Fig. 4).
2.
Attach aluminum pump
pump. Place pump into a bucket and position near saw (Fig. 5).
3.
Fill the bucket with approximately 3 quarts of water to cover pump before use.
4.
Plug pump's electrical connector into the outlet on the front of the saw (Fig. 6).
5.
To test pump, the saw must be turned ON. Be sure the blade has been properly
installed and there are no obstructions to interfere with its operation and blade
movement. DO NOT attempt to touch the blade or blade wheels while the machine is
turned ON.
6.
Test pump and water
Water should begin to
Insure water
is directed at the front edge of the blade just below the guide
assembly. Adjust position of water nozzle by loosening the nut on the front of the
shield, using the crescent wrench (Fig. 7). Reposition the nozzle for appropriate spray,
and retighten.
7.
If large pockets of air appear in the hose, this may stop the
If this occurs, prime the pump by tipping it on its side and allowing the intake to draw
in air through the line. Then return the intake into the water and watch for the water
to
the line. Small air bubbles may persist in the line but these will not interfere with
to the blade.
WARNING: Never operate saw if there is
this will
into the opening on the side of the recirculating water
by turning machine ON. Watch for bubbles in the hose.
freely from the water nozzle mounted on blade shield.
to the material
PAGE 2 -
DL7000 INSTRUCTION MANUAL
of water to the blade.
water at the point of
as well as the blade.
as
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
Advertisement
