Kidde 30CUA10 User Manual page 18

• After selecting the proper location
for your alarm, and wiring the AC
QUICK CONNECTOR harness as
described previously, attach the
mounting bracket to the electrical
box. To ensure aesthetic alignment
of the alarm with the hallway, or wall,
the "A" line on the mounting bracket
should be parallel with the hallway
when ceiling mounted, or horizontal
when wall mounted.(See Figure 9-F)
• Pull the AC QUICK CONNECTOR
through the center hole in the mount-
ing bracket and secure the bracket,
making sure that the mounting
screws are positioned in the small
ends of the keyholes before
tightening the screws.
• Plug the AC QUICK CONNECTOR
into the back of the unit, making sure
that the connector snaps into place.
Then push the excess wire back into
the electrical box through the hole
in the center of the mounting bracket.
• Install the alarm fully on the mounting
bracket by rotating the alarm in a
clockwise direction. (see Figure 9-C
for orientation)
NOTE: The alarm will mount to the
bracket in 4 positions (every 90
degrees).
NOTE: Installing the alarm on the mounting bracket will automatically activate the battery backup.
• Turn on the AC power. The green AC Power On Indicator should be lit when the alarm is operating from
AC power.
18
AC Quick Connector
harness shipped
with product
AC connector
Remove
Alignment Marks
("A" Line) on
Mounting
Bracket
Insert the AC
Quick connector
into the slot.
Install
Figure 9-F