Table of Contents
Advertisement
Listening to Tape
REVERSE MODE
#4 (7PS)
DECK 1/2
ES)
Eee]
To find the beginning of a program
(TPS: Tape Program Sensor)
Press <q or B® while the tape is playing.
If the forward side (@) is playing:
>
The tape will play from the beginning of the next tune.
"@4; The tape will rewind to the beginning of the present tune.
Then the tune will play again.
If the reverse side (4) of the tape is playing:
The reverse operation should take place.
TPS is the function that searches for the silent passage in a tape
program. So, it may sometimes fail to operate correctly in the
following situations:
® When
there is no blank space between tape programs
(for
example, a tape recorded from a microphone)
@ When the interval between programs is less than 4 seconds
@ When there is a particular low-level passage in a program (for
example, classical music)
® When the program is less than 10 seconds, or when it is less
than 10 seconds from the beginning of the program to the
beginning of the next program
@ When a tape recorded with fade-ins or fade-outs
To fast forward or rewind the tape
Press <¢<d or >> while the tape isin the stop mode.
Pr:
The tape will be fast forwarded.
44:
The tape will be rewound.
For your reference:
You can fast forward or rewind the tape while you are playing a
tape in another deck. Press DECK 1/2 to switch to the non playing
deck, and then press <#<@ or BB. After above operation, be sure
to press DECK 1/2 to select the deck in which you are playing a
tape.
Sequential playback among 2 tapes:
1. Press
& EJECT on decks 1 and 2, and then insert the tapes.
Insert with the side that you wish to listen to first facing in you
deck 1.
. Prass REVERSE MODE to select "¢z>" mode.
. Press DECK 1/2 to select deck 1.
"DECK 1" will light up.
4, Press >,
Forward side ai tape in deck 1
on
Reverse side of tape in deck 1
+
Forward side of tape in deck 2
L
Reverse side of tape in deck 2
After repeating above operation 8 times, the tape will automatically
stop.
To stop tape playback:
Press 0.
For your reference:
You can also start playback from a position other than the forward
side in deck 1.
About "DECK 1/2" indicator
When you load tapes in both decks, deck 1 or 2 indicator will fight
to show which deck you loaded last.
When you switch on the power when two tapes are loaded in both
decks, "DECK 1" will light.
Advertisement
Table of Contents
