Step 3 - Setup The Drive - Maxtor ONETOUCH III User Manual

CHAPTER 2 INSTALLING THE ONETOUCH III
Connecting the USB Cable
1. Plug the larger end of the USB cable into an available
USB port on your computer.
FIGURE 4 CONNECTING TO A USB PORT
2. Plug the smaller end of the USB cable into the USB port
on the back of the drive.
3. Proceed to Step 3 – Setup the Drive.

Step 3 - Setup the Drive

If the Welcome to Maxtor OneTouch Setup screen is still
visible, click Cancel to close it. Your computer may require a
restart to complete the hardware installation.
Your new drive will appear in the same way as your other
drives, with a letter assigned to it by the operating system.
The assigned letter will vary depending upon the number of
other drives connected to your computer.
1. Press the OneTouch button. The Maxtor OneTouch Manager
launches into the Backup: Settings Step 1 of
2. Select the folders you wish to back up.
Click Next.
2.
PAGE 8