Mac Faucets ASD-23 User Manual

Installation Instructions
4"
ASD-23
Make sure that there is
8" minimum distance
between top of sink to
bottom of soap
dispenser
Fig. A
Place the plastic anchors in the holes. Drive them
05
in with a lite hammer.
Automatic Foam Soap Dispenser
Package Includes
Soap Dispenser
Stainless Steel Construction
Dispenses Foam Soap Only, commonly found in retail stores
1000ml Integral / Soap Bottle
Vandal Key
Integral Battery Compartment
Mounting Hardware
Batteries Pre-installed
All hardware necessary for satisfactory installation
Tools Needed
Safety Glasses
Hammer
01
03
04
Drill Holes Ø 1/4"
Please cut for drilling holes
Align the holes of
06
the dispenser with
the holes of the
anchors. Insert
screws in and
fasten using a
Phillips screw
driver.
User Manual
Model: ASD-23
(6 AA)
Level Cordless Drill
Phillips Screw Driver
02
Once the location for the Soap
dispenser has been decided,
proceed with the installation
steps below. If the soap
dispenser is installed above the
sink, leave a space of 18" from
the top of the sink to the soap
dispenser as shown below in
figure (A).
1. Cut the template from the
back of the dispenser box.
2. Use a level to align the
template correctly.
3. Use painters tape to hold the
template in place.
4. Drill holes for supplied plastic
anchors.
Insert the key into the hole
07
located at the top of the
dispenser, push down with the
key and pull the cover forward.
The cover engages a power
cut-off switch located in the
dispenser. The dispenser will
not activate when the cover is
in the open position.
Drill bit
Ø 1/4" Carbide
Drill for tile
Tape
PAGE | 01