Jeken JRFS293CBW-11 Manual page 43

Space Requirement
Select a location without direct exposure to sunlight;
y
Select a location with enough space for the refrigerator doors to open easily;
y
Select a location with level (or nearly level) flooring;
y
Allow sufficient space to install the refrigerator on a flat surface;
y
Allow clearance to the right, left, back and top when installing. This will help
y
reduce power consumption and keep your energy bills lower.
Keep at lest 50mm gap at two sides and back.
y
Location
The appliance should be installed well away from source of heat such as
radiators, boilers, direct sunlight etc. Ensure that air can circulate freely
around the back of the cabinet. To ensure best performance, if the
appliance is positioned below an overhanging wall unit, the minimum
distance between the top of the cabinet and the wall unit must be at least
50 mm. Ideally, however, the appliance should not be positioned below
overhanding wall unit. Accurate leveling is ensured by one or more
adjustable feet at the base of the cabinet.
The refrigerator appliance is not intended to be used as a built-in appliance.
Warning! It must be possible to disconnect the appliance from the
mains power supply; the plug must therefore be earsily accessible
after installation.
Electrical connection
Before plugging in, ensure that the voltage and frequency shown on the
rating plate correspond to your domestic power supply. The appliance must
be earthed. The power supply cable plug is provided with a contact for this
purpose. If the domestic power supply socket is not earthed, connect the
appliance to a separate earth in compliance with current regulations,
consulting a qualified electrician.
The manufacturer declines all responsibility if the above safety precautions
are not observed.
This appliance complies with the E.E.C. Directives.
INSTALLATION
9